crgary_tx
asked on
Set Datasource Location
I have a report basing a view. Now I need to test the report for the data on the production d/b where i do not have permission to create the view. So i am trying to replace the view with the command from the other d/b using 'Set Datasource Location'. For some reason the command is not being updated as the new datasource either on a different d/b or even the same d/b. So a view cannot be replaced by the command? How can I make report work for the new datasource without recreating the report?
TIA..
Gary
TIA..
Gary
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
It may have to do with the fact that a COMMAND is similar to a stored procedure.
mlmcc