intersource
asked on
How to setup PIX with Westell DSL Modem and Bellsouth?
I have been having a hard time setting up a PIX 501 with a Westell DSL modem through Bellsouth service. I have the Westell setup in Bridged mode and have setup the PIX with the correct PPPoE information via startup wizard. I am able to ping the outside world via the outside interface but not the inside interface. I have tried both static and dynamic settings for the PPPoE server setup, thinking that I had a routing problem. Any suggestions??
ASKER
I will give this a shot to see how it works. Thanks!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
In addition you also need a NAT rule in place so that all traffic from the inside will be translated to a public internet address. This can be the address of the firewalls outside interface. Here is a guide for setting up a pix for basic internet access:
http://www.linuxhomenetworking.com/cisco-hn/dsl-pix.htm