Print Server Dlink DP-300U not printing

I tried (1) myself and changed it to DHCP and now again I cannot access the web browser

If this is any help I have changed the router to Linksys WRT54GS from DLink DGL 4300 for the time being as the latter has gone for repairs/warranty. I do not think changing f the routers will make any difference

The default web browser IP Address for the DLink Print Server is 192.168.0.10
The default web browser IP Address for the LInksys Router is 192.168.1.1
The default web browser IP Address for the previous router DGL 4300 was 192.168.0.1 which is more or the less the same as the D Link Print Server.
Why the Dlink Print Server is not be working  because it may not have same IP network settings as the local network.
I hope some gurus & geniuses may comment on this

i think it is simply bad; i suppose you power cycled it already several times?

After two days of great effort I found the solution my self In network of the web browser of the print server simply change the default gateway of the web IP address of the print server from 0.0.0.0 to 192.168.1.1 the default gateway of the linksys router and lo! God be great The print server started functioning
As far as to access the web server I simply followed the manual as in consecutive steps:
(i). Connect the ethernet cable from the switch to the print server
(ii). Connect the printer cable to the parallel port of the print server
(iii). Power on the printer
(iv) Power on the print server.

For further help and elaboration to any body who faces this similar problem.
In the DLink manual it advises that the default IP address to be 192.168.0.10. That worked fine with me as long as I used the DLink Gigabit switch and the Dlink gaming router DGL 4300.
However this all changed when I purchased the Linksys WRT54GS  because the DLink router went for repair/warranty.
The changing of the router made the DLink server router not to communicate with the PC and the printer failed to print. I managed sometimes to make the printer print by giving a static IP address of 192.168.0.X in the PC but this was definately not the solution.
Digging deep in memory I remembered that by merely changing the ethernet cable would sometimes bring the print server to communicate with the Pc although the previous used to be OK. therefore I kept on changing between two cables and finally the print server started communicating as shown by the PS ADmin software.
That software indicated that the IP address of the print server had changed to 192.168.1.102 instead of what was in the manual bok viz 192.168.0.10.
And that the default gateway had changed to 192.168.1.1.
I typed the 192.168.1.102 and the web browser appear. Then it was easy to set up the print server.
In the efforts I also tried the static address of 192.168.0.10 the former IP address of the print server. But that did not work but instead put my broadband cable down. It took me a day to realize what had happened.
I am not a computer expert in any way but fortunately I have found a solution to a technical question which Dlink support was not giving and nor did any expert helped me. I hope  that some real computer guru and sage would appreciate that a novice to intermediate computer user like me found a solution by himself. I wish that more experts would join in answering my questions whose profiles makes astonishing reading

The static address was fed in the router which made the internet cable down. The Linksys router is more techinical than the D Link one.