ok, yes on nat. Should I open a new question on upgrading the IOS? I show version 12.2(7r)XM2 now. I am a network novice, but I am pretty good at follwing instructions.
Main Topics
Browse All TopicsMy Cisco 1760 is already programmed and providing internet to the one fast ethernet port from my T1 connection. I just now purchased a WIC 4ESW card that I want to install and connect more computers directly to this router when, and if, my primary router fails. What command(s) do I need to enter to set this card card up correctly? IP information from T1 provider is attached.
This Question has been solved and asker verified All Experts Exchange premium technology solutions are available to subscription members.
Experts Exchange has been collecting answers to technology questions since 1996…3 million and counting! If you have a question, chances are we already have your answer.
If you can't find the exact answer you're looking for, ask our exclusive community of 50,000 experts. You’ll get a personalized answer from a trusted professional.
Thousands of free tech tips, tricks, how-to’s and tutorials are available in our peer reviewed articles section. See for yourself how smart our experts are, no login required.
Access the answers to your technology questions today.
30-day free trial. Register in 60 seconds.
Members of the expert community talk about why the experience at Experts Exchange is different than what you will find anywhere else.

Try it out and discover for yourself.
30-day free trial. Register in 60 seconds.
Join the community of experts here and help other tech pros by answering question in your area of expertise. You can earn FREE access to all Experts Exchange's premium features and resources.
Firsty you must buy shared support, and than you able to get it from CCO web....
the code:
controller T1 1/0
framing esf
linecoding b8zs
channel-group 0 timeslots 1-24
!
interface serial 1/0:0
ip address 169.130.180.126 255.255.255.252
ip nat outside
!
interface VLAN 1
ip address 205.232.102.49 255.255.255.240
!
interface VLAN2
ip address 192.168.100.1 255.255.255.0
ip nat inside
!
ip route 0.0.0.0 0.0.0.0 169.130.180.126
!
ip nat inside surce list 1 interface serieal 1/0:0 overload
!
acces-list 1 permit 192.168.100.0 0.0.0.255
acces-list 1 deny ip any any
Please refer this guides:
http://www.cisco.com/en/US
Please ask the encapsulation for ISP the T1 PPP or Frame relay or HDLC?
Business Accounts
Answer for Membership
by: ikalmarPosted on 2009-09-16 at 21:04:03ID: 25352772
Hi, fristly you must upgrade the IOS to 12.3.14T or later, becouse it supported it!
do you want to nat? becouse the customer WAN contains only 1 IP address to use+