Card Type command not working on Cisco 2811?

I have a Cisco 2811 running ios 12.3(8)T7

We've been running a single t1 on it for years, we've just decided to upgrade to 2 t1s and picked up a 2 port wic.  The wic didn't light up as expected when first installed and I've discovered I need to use the Card Type command to configure it first.

if I try this, I get a ^ under the d in card.... From looking up the command, it appears it was imp'd before my ios version and thus included, so I can't figure out what the heck the issue is. ThanksStart Free Trial