I have a Cisco 1760 that I recently reset to factory defaults...below is what I see currently on bootup in HyperTerminal...........
System Bootstrap, Version 12.2(7r)XM2,
TAC Support:
http://www.cisco.com/tac Copyright (c) 2003 by cisco Systems, Inc.
C1700 platform with 65536 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0x72af08
Self decompressing the image : ##########################
##########
##########
### ##########################
##########
##########
### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
MainBoard 0X00027A80 1760
0X000F3BB0 public buffer poo
0X00211000 public particle pools
0X0011 0X0000DC00 Card in slot 0
0X0002 0X0000DC00 Card in slot 1
TOTAL: 0X00347E30
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Allocating additional 6737305 bytes to IO Memory.
PMem allocated: 56931383 bytes; IOMem allocated: 10177481 bytes
Restricted Rights Legend
Use, duplication, or disclosu
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-IPBASE-M), Version 12.3(6), RELEASE SOFTWARE (fc3
)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 20:25 by kellythw
Image text-base: 0x80008120, data-base: 0x80C73660
cisco 1760 (MPC860P) processor (revision 0x500) with 55597K/9939K bytes of memor
y.
Processor board ID FOC08091V6N (4020939319), with hardware revision 0000
MPC860P processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
1 Serial(sync/async) network interface(s)
WIC T1-DSU
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
__________________________
__________
__________
__________
______
I have a WIC 1DSU T1 Card and wanting to setup the 1760 with my cable provider, I have one static IP from my ISP and the SMC Gateway is configured to bridge mode.
I would like to use NAT on my workstations.
If any what are my options and would you guys please provide a sample config file to get this running.
Thanks for the assistance.
Start Free Trial
