How do I configure a Cisco 877 Router into bridge mode using the two SDM interfaces?
I have configured the router successfully to connect to the ISP and provide internet via the 877's NAT & firewall. I now need to setup the 877 into bridge mode to add a preconfigured watchguard firewall. my test of bridge mode has been trying to ping the Cisco 877 from behind the watchguard firewall. I have four external IP addresses and the first is for the Cisco and the second is for the watchguard (all other parameters are the same as it was in a similar bridged router configuration before albeit different external IP address and gateway.)
1. Can someone please advise how to setup the Cisco 877 in bridge mode just using the SDM interfaces?
2. If this has to be done by configuration upload, can you please provide URLs which detail this process?
Many thanks in advance.
Cisco Newbie
1. Can someone please advise how to setup the Cisco 877 in bridge mode just using the SDM interfaces?
2. If this has to be done by configuration upload, can you please provide URLs which detail this process?
Many thanks in advance.
Cisco Newbie
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
An ex-colleague used my Experts Exchange login to ask this question & despite frequent requests has not bothered to sign it off. I'm left with no alternative but to sign it off myself with no knowledge of the problem or if your kindly offered solution resolved the issue or not. I have therefore given you the highest ratings possible (& changed my password) but not added the question to the Knowledge Base in case it is not fully correct.
My apologies, & thank you for your help - I expect it was of use to my ignorant ex-colleague!
Best regards,
Dave.