asked on

Policy based routing Procurve 5412zl

I am looking to split my traffic to two different ISP's based on VLAN. I have a HP 5412zl switch handling my vlan routing & currently have my default route set to a Fortinet firewall (int F21 on switch). I would like to split one VLAN, 10.5.x.x, and send all of their traffic out to a different firewall [sonicwall] (int F15 on switch).
Fortinet : 10.10.0.2
Sonicwall: 10.20.0.1
5412: 10.1.0.70

I can't find anything on PBR for the Procurve. Thoughts?
TIA. -John

Don Johnston

The 5400 series can't do PBR. IIRC, you have to have a 9000 series before you can do Policy Based Routing.

Flying_Toaster

ASKER

Thats not good. any sugestions on how to accomplish this? Stick another device in between the 5412 & firewalls that is capable of PBR? or is there another way to do this?

ASKER CERTIFIED SOLUTION

Don Johnston

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Flying_Toaster

ASKER

Other way to do this, set the default gateway on the one vlan (10.5.x.x) to the IP of the 2nd firewall. Leave everything else the same. (2nd firewall needs to have routing table setup).

zobster69

Policy Based Routing is now supported on the 5400 series switches using software version 15.06.0006 or later. See the advanced networking guide section 8 page 1

http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c03015541/c03015541.pdf