My router connects by cable to an ADSL modem. IT also connects by cable to another computer and the wireless function connects the internet for a laptop.
The computer that connects the router...
Hello everyone,
Long time lurker, first time asking.
I was recently given an asa 5510 to deploy which will replace our citrix server as well as our linux iptables firewall.
I have most th...
I am clueless on how to resolve this issue. I have an MTU ping test of 1476 and don't know how to track it down. I am thinking I am going through a GRE tunnel and that is causing the problem.
...
I have a BGP network that I want to redistribute into my OSPF network. I did:
router ospf 1
redistrbute bgp 65534 metric 100
but I don't see any of the BGP networks being advertised. ...
Has anyone got any good documentation on configuring the draytek 2820 or best practice guides.
I have read the manuals but they are not very good.
I would like to be able to setup the web co...
i have a 3845 connected to a 2610 via T1 point-to-point. started having problems with connection staying up. constantly goes up and down when a big load is on it, and sometimes when there is...
Hey everybody,
I just purchased the cisco 881 and I am having trouble configuring the Fe Lan ports. I know that you cannot set the Ip address directly to the port, but I can't setup dhcp or...
Hi,
This is quite a trivial exercise but I'm trying to rename my router. I decided to do it (thinking it would be easy) but failed. I then tried harder and still failed. Now I've gotten stubb...
I was changing the shared key in my router settings. In the middle of saving, the power went out (imagine that timing!). Needless to say I had to reset the router. I can access router, usernam...
Hi everyone!
Perhaps this is an easy question but I just can't get this to work. I have a customer who has the Time Warner basic road runner service. She is connected to the Internet via ...
Is my Dlink Di-524 QoS capable?
Someone recommended the Linksys WRT54G, but I would rather keep my dlink.
I do have VOIP from primus and have Cable internet
here is my Setup
Cable-Modem --> D-Link DVG-1120M Voip Router --> Linksys Wireless G Router With SRX
Now I have disable DHCP server ...
I get this message.
04:12:34: %RCMD-4-RSHPORTATTEMPT: Attempted to connect to RSHELL from x.x.x.x
04:17:25: %CRYPTO-4-IKMP_NO_SA: IKE message from x.x.x.x has no SA and is not an initial...
I am getting this ROMMON upgrade initialized and Initializing ATA monitor library on Cisco 1811 router. It keeps on rebooting an never get into prompt. What you think , the issue and remedy is ?
Hi All,
I'm trying to configure vlans in Cisco 3825 using HWIC-4ESW module. The router shows the module is installed properly and I configured the VLAN too. but the line protocol of the FE ...
I´m getting a "Limited or no connectivity" status on my D-LINK (DI-524) wireless router connection.
I double-click on the Wireless Router´s icon on the Taskbar and point to Support and then ...
Hello Experts,
I am looking for the appropriate command(s) for switching the boot image on a Cisco 4506E with a Sup6E. I have successfully tftpd the new image to the router but all effort...
I just installed DD-WRT on my linksys WRT54G just so that my range can increase as when i use my iphone one floor below i get 3 to 4% signals...any advise on how to increase the throughput of ...
I have a Cisco 3845 router with a 4 port t1 wic and a newly installed DS3 card. The 4 port wic shows up fine and I was able to see it by issuing the #card type T1 0 0 command. However the DS...
I would like the "translations" of the following Cisco commands for a ProCurve Switch. I also understand that what ProCurve calls a trunk "translates" to an etherchannel in Cisco lingo, is thi...
I have a problem with erasing the NVRAM on a CISCO 2621XM
============================================================
============================================================
...
I'm wanting to remote into workstations at different sites from my office. We currently have Fortigate 60 routers at each site. I know I need to setup port forwarding on the router, but I don'...
Hello experts,
We're getting internet turned up at our office next week and I just spoke to our ISP's engineer & from what he's telling me I'll need a router that will be assigned 1 of our ...
Hi Everyone:
I have recently purchased a LInksys Wireless-G Broadband Router, Model Number WRT54G. Due to the fact this router never came with a manual, I am interested in any infor...
Hello, I wish to forward http and https traffic from my internal LAN to a Squid proxy server (also located on my internal LAN).. I'm using a Juniper Networks Netscreen 5GT Details are as follo...
