fntech2009
asked on
Cisco 2960 Inbound Rate Limiting Command
Hi,
I used srr-que command to do outbound bandwidth limit and I've used this command example to do inbound rate limiting on Cisco 2960.
mls qos
ip access-list extended ACL_SLAP
permit ip any any
class-map match-all CLASS_SLAP
match access-group name ACL_SLAP
policy-map POLICY_SLAP
class CLASS_SLAP
police 8000000 100000 exceed-action drop
interface GigabitEthernet0/2
service-policy input POLICY_SLAP
I dont really understand whats the correct burst size that need to be configure for 1mb, 10mb, 100mb or so. Need an expert advise to enlighten the correct burst size and for each rate limiting mentioned above.
I used srr-que command to do outbound bandwidth limit and I've used this command example to do inbound rate limiting on Cisco 2960.
mls qos
ip access-list extended ACL_SLAP
permit ip any any
class-map match-all CLASS_SLAP
match access-group name ACL_SLAP
policy-map POLICY_SLAP
class CLASS_SLAP
police 8000000 100000 exceed-action drop
interface GigabitEthernet0/2
service-policy input POLICY_SLAP
I dont really understand whats the correct burst size that need to be configure for 1mb, 10mb, 100mb or so. Need an expert advise to enlighten the correct burst size and for each rate limiting mentioned above.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER