|
[x]
Posted via EE Mobile
|
|
| Search, ask, and monitor your questions on the go with EE Mobile. Visit Experts Exchange from your mobile device and never be out of touch again. |
|
|
|
|
|
[x]
The Solution Rating System
|
|
| With so many solutions, how can you tell which solutions are most likely to help you and which ones are not? To provide you with a tool to use, we rate our solutions based on various elements that most accurately determine if a solution is a quality solution. To explain what factors affect the solution rating, here are the elements we take into consideration when formulating our solution rating. - The Grade of the Solution
- The Zone Rank of the Expert Providing the Solution
- The Number of Author and Expert Comments
- The Number of Experts Contributing
- The Feedback of the Community
Your Input Matters Because of the way the system is set up, the most important variable in this equation is you. As a member of Experts Exchange, you are able to cast your vote on the quality of the solutions in regard to how complete, accurate, helpful and easy to understand each solution is. When you provide your feedback, each rating is adjusted accordingly. So, if you see a solution that has a poor rating that you think is a good solution, let us know by rating it. As you do, the rating will be adjusted and will become more accurate for other members of our site. If you have any suggestions that you would like to make for our rating system, please ask a question in the Suggestions Zone of Community Support. Thank you! |
|
|
|
|
Asked by DOCDGA in Network Switches & Hubs, Storage Technology, Databases Miscellaneous, Storage
We have four IBM servers with one HBA per server. We have one DS3400 SAN with two HBA's and one 2498 Brocade FS.
We have configured an alias for each WWN involved. In the default zone we have included all the ports in the port group, All the WWN's of the devices connected to the switch, and an alias for each device(WWN) that is connected to the switch.
The default zone is in the default config and the the config has been saved and enabled.
We are using IBM System Storage DS Storage Manager 10. Auto Discovery finds the DS3400. When we go to configure Hosts are not found automatically or manually.
We have never fully configured a Brocade switch for a SAN before and we can't figure out why Storage Manager can't pick up these hosts. We have gone through the available documentation on configuring this switch without success.
Any assistance would be greatly appreciated.
20091111-EE-VQP-89 - Hierarchy / EE_QW_3_20080625