Hello:
I just purchased a Linksys WAP200 access point and need to configure it to be in repeater mode. My LAN network default gateway is 10.10.10.1. I currently have a LInksys Wireless Router/AP, and want to repeat that signal. On the WAP 200 AP, the default address was 192.168.1.245 when you first plug it in. I connected to it, and did the following. First, I changed the IP addressing on it to DHCP, then I went in and to AP Mode, and selected repeater, and put in my router/ap's mac address. The clients see the WAP200 acess point/signal, but can't get an IP address to connect, but can just fine from the first AP.
What do i need to do to get this up as a repeater so they can connect?
Start Free Trial
