Curtis Long
asked on
Mapping LPT1 to network printer
I have an XP laptop with an old DOS program called GeneriCAD.
Laptop name is john-laptop
I have a Canon IP100 printer.
I have hooked the printer up via USB, shared the printer as Canon
I run the following command:
net use lpt1 \\john-laptop\canon
I receive the "Completed successfully" message.
BUT, when I attempt to print to the printer from GeneriCAD via LPT1 I get nothing.
I CAN print a test page via USB but NOT via LPT1
Any thoughts??
Thanks!!
Laptop name is john-laptop
I have a Canon IP100 printer.
I have hooked the printer up via USB, shared the printer as Canon
I run the following command:
net use lpt1 \\john-laptop\canon
I receive the "Completed successfully" message.
BUT, when I attempt to print to the printer from GeneriCAD via LPT1 I get nothing.
I CAN print a test page via USB but NOT via LPT1
Any thoughts??
Thanks!!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
The brother HL2250DN and 2270DW are PCL6 printers and would probably work, and they are pretty small for laser printers, although I wouldn't exactly call them portable:
http://www.brother.co.uk/display.cfm/id/335473/disp_type/display/filename/2200%20Series%20Leaflet.pdf
The PJ623, a portable printer that supports ESC/P could also work as that was used by many epson and compatible dot raster printers which were common in the days of DOS.
http://www.brother.co.uk/g3v1/g3.cfm/s_page/215760/s_level/16860/s_product/PJ623Z1
http://www.brother.co.uk/display.cfm/id/335473/disp_type/display/filename/2200%20Series%20Leaflet.pdf
The PJ623, a portable printer that supports ESC/P could also work as that was used by many epson and compatible dot raster printers which were common in the days of DOS.
http://www.brother.co.uk/g3v1/g3.cfm/s_page/215760/s_level/16860/s_product/PJ623Z1
ASKER
Any thoughts on which one to use??