I have obtained a s/h DL380 G3 with all the trimmings - dual CPU, loads of ram, six disks on the optional add-in SCSI raid controller... and that's the snag. I've downloaded the latest SmartSt...
Our IT department is at best a bastion of laziness. No one is willing to accept responsibility for anything, and this occurs at the CIO level, all the way down through our 40 member staff. Be...
hi,
I have a Dell poweredge 2600 server with Perc 4 raid controller. Raid5 configuration with 5 drives.
Hard drive in slot 0 failed and took server down.
Array was in degraded state. Took d...
How do I disable hyperthreading on a dell power edge 2950?
Thanks
Hi All,
I'm trying to make images of systems to deploe with ghost - the version i have is one of teh newer ones, have they changed teh functionality or am i missing something.
To take t...
Hello,
We have a Dell PowerEdge 2850 with a PERC 4e/DC configured as a RAID 5. This afternoon an alarm went off and one of our drives is now blinking amber.
Is it possible to try and re...
I attempted to migrate our blackberry server to new hardware, and performed the steps outlined in RIM's cut over. (turn off serrvices, install on new system, bring it online, etc).
Now whe...
I have a Windows 2003 box running Citrix Presentation Server 4.5 with all hot-fixes installed. It is running on a HP DL370 G4 server that has a X3.6 800Mhz 1mb processor with 4GB of RAM and 3 ...
After rebooting the server it has now gone into a continuous reboot. I am trying to get to the recovery console but cannot get the scsi drivers loaded have contacted dell but the link to the...
Hi - have a Dell SC440 server purchased less than a year ago, misplaced the driver discs, and cant locate the driver for the onboard NIC for the server. I've tried basically every intel/broadc...
Dell Remote Access Card
My DRAC5 card will not connect to the 'Console Redirection' (where you control your desktop remotely). I am getting the following error when attempting to connect:
...
I know this question has been submitted many times, and I have gone through most of the posts. We have a Proliant DL380 G3. The fans are very loud. They never change from the time the power...
Hello,
I just purchased this server off ebay and do not know much about the older Dell PowerEdge setups. It has a Dell PERC 3/Di which I assume is also an Adaptec AIC-7899?
How do I ente...
The alarm in my Dell Poweredge 2850 has been beeping non stop for hours. One of the three hard drives on my RAID 5 array was removed (don't ask) while the system was live. The drive was immedi...
Our Dell Poweredge 830 server, (2 gig ram, Sata Raid) has been running Centos Linux (3 & 4) for about 18 months now, no problem.
===>Problem: Instead of the steady blue led on the front pa...
We just picked up some used Dell PowerEdge 2650s. They came completely wiped so we loaded Windows Server 2003. Windows seems to be running fine although the video seems a little choppy.
P...
Restarting the server we get below message
"Amount of available memory limited to 256 MB!
Strike the F1 key to continue, F2 to run the setup utility"
My RAID controller failed. If I replace my controller, will the system still boot back up, in theory? The server has been down for almost 48 hours. It's not mission critical, but I do need ...
I must be missing something simple. I've been trying to get SMC services running and I'm running into problems all over the place. Ultimately, I need to create a RAID 5 volume. I cannot get...
We are currently looking into purchasing a complete solution for our company from one of three vendors - HP, Dell and IBM. We are looking at purchasing a Blade solution and a Fibre Channel SAN...
I would like to setup an ISA 2006 array to do the following:
==============================================================
Balance the load by direction of network traffic (Inbound & Outb...
Hello and Good day!
We are currently using Dell 2850 server with RAID 5 configured hard drives, What is the proper way of replacing a failing hard drive? Do I just pull one drive out th...
Hi,
I have a server with this error logged in the event log:
Event Type: Error
Event Source: Srv
Event Category: None
Event ID: 2019
Date: 21/01/2008
Time: 08:40:17
User: N/A
C...
Hi,
Hope you can help as this problem has been ongoing now for a number of months, I have joined this site specifically to fix this problem. As it is slowly driving me insane !
I have a ...
On my Windows 2000 Server I get the following error :
STOP:C0000218 {Registry File Failre}
The registry cannot load the hive (file):
\SystemRoot\System32\Config\Software
or its log or alte...
