The instructions are correct regarding making the secondary router i.e. DI-525 as Access Point. However you need to ensure that the Ethernet Cable from the main Router i.e. DI-614+ should go to any of the LAN Slots rather than the WAN slot.
Sometimes, you may require a cross-over cable to do this.
Main Topics
Browse All Topics





by: baconyiPosted on 2005-12-05 at 07:13:33ID: 15419825
heres somethings to check/configure,
im assuming you know how to get into the configurations pages because you said you've read the instructions and tried to do some things already.... but heres from the very beginning...
verify if the 614 works when you plug a pc in, im sure it does... then plug in the 524 and change its IP to an address outside the range of the 614's dhcp... since you changed it into an AP it should be correct,
on a wireless pc, goto the command prompt, try releasing and renewing the IP (ipconfig /release, then ipconfig /renew)
see if it picks up ip address's,
let us know what the address's are that it picks up if any.
Billy