Can you use a VWIC-2MFT-T1 "2 port voice interface card" to terminate 2 data T1's to?  If so, how do I configure the controller 0/3/0 & 0/3/1 interfaces to accept IP addresses?

Hello, we have a VWIC-2MFT-T1 dual voice T1 card in a Cisco 2811.  I was asked to use this one and only card to configure 2 data T1's on.  The router recognizes the VWIC card as Controller 0/3/0 & 0/3/1 interfaces.  I rarely work in the voice world and have never configured this type of card.  I'm used the the router recognizing T1 interfaces as serial interfaces.  Thanks.

controller T1 0/3/0
 framing esf
 linecode b8zs
 description
!
controller T1 0/3/1
 framing esf
 linecode b8zs
 description Start Free Trial