I'll try to explain the diagram (attached below) and then relate my question . The question appears a bit long because I tried to simplify it as much as possible for you guys to understand so ...
Hi Guys,
I have an issue between a Dell 6224 and a Dell 5424 which are trunked. The switches are connected together via port 1/g1 on the 6224 and port g1 on the 5424.
The configs are liste...
My network is represented in the attached diagram. The left side is how the network currently looks. The right side is the equipment I am going to add to make this network more redundant inc...
Hi Guys,
I have tried to make the attached diagram as simple as I could. The scenario is:
Till recently we had only one ISP1 giving us intrasite MPLS VPN connectivity. We ran into major ...
PVLAN Configuration on 2 Switches
Hello,
I'm trying to configure PVLAN on 2 switches including Virtual Distributed Switch.
My 2 switches are:
A: vDS (PVLAN Supported)
C: CISCO 4506 (PVL...
I have a Checkpoint Firewall and I need to configure OSPF Routing to L3 Cisco Switches in another site which are connected by 2 LES Circuits by 2 differnet provider, the 2nd circuit is resilen...
Hello Experts,
I have a Netgear Access Point wireless router which is connected to my broadband directly. I have a desktop computer connected through wire and a wireless laptop connected to...
Hello and thank you for taking the time to read this question.
Please check if my understanding of EIGRP is correct. Below is an example of my environment and I will be expanding on this e...
Hi experts,
I have a cisco 2960 switch with vlans and from here trunk port to a cisco 2800 router.
Even the configuration on the end-hosts are the same in area 1 and area 2, i can only ping...
We run a small hosted services ISP. We currently have two Cisco routers each doing BGP to a a few Tier1/Tier2 providers for redundancy. We have just joined a peering exchange and are in the pr...
Took over a network from another IT company. No notes, no documentations.
They have a SonicWall TZ180.
I can't access it.
The default gateway is 192.168.23.1.
I can't open it in an IE win...
I am having a challenge that I am not sure the best way to solve:
I am replacing an aging PIX with a new ASA 5510. One thing I want to take advantage of is that the ASA supports virtual in...
Hi all,
a basic question but i thought i would ask it before i go ahead and do it!
our current network is currently running across one floor (the top floor), we have one server and 10 pc...
Hello Experts,
I hope someone can help me with giving some input about configuration and possible design flaws which cause our proposed new office network to lose connectivity for a few sec...
I'm trying to understand why I cant connect to a server that has been given a static ip of 192.168.1.1 from an existing computer in a network. The computer's ip address is 10.0.0.5.
I can't e...
Hello,
We are planning to change our current topology to use VLAN. The main reason is due to relocation and hence not to restrict groups of users to the same location or floors in the buil...
So, here's the deal:
We have two office on separate subnets connected through an MPLS. We want to set up a secondary connection through another ISP with a VPN connection between offices and...
I am trying to change our network from one gigantic LAN to two different LANs and then also incorporate our WAN with the same switch.
I bought an HP procurve 2910 with the hopes of being ab...
Hi,
I have network of 4 servers and 4 staff computers. I currently host Exchange SharePoint and I have Domain controller which replicates to different company sites. We are basically the co...
Before I attempt this Im looking for advice on web proxy&I have a server with which I want to create a web proxy using Squid. Want my users who are at another branch to do all their browsing...
We are geeting one Equallogic PS4000 iSCSI SAN (dual controller) with Dell PowerConnect 5424 Gigabit switches supporting jumbo frames.
There will be be 2 Ethernet Gigabit ports (w/ TOE) on...
Hello,
I'm searching for a solution that is similar to Private VLAN. I have machines that are in the same subnet but I don't like that they communicate with each others.
My switch doesn't su...
Hello fellow expert-exchangers! Ive been tasked with following request by my manager and searching for best path to completion. He was jotting down some thoughts on flight back from conferenc...
We have a media server (running xp pro) on 2.0.0.6 controlling a host of projectors and lighting on this network. Subnet is 255.255.255.0
We also have a regular network on 192.168.100.x, su...
Hi,
I am trying to understand exactly why there are interlinks (either trunks, etherchannel or layer 3 router links) between the switches in the access (or distribution) layer of Cisco's 3...
