Greetings,
I may be joining a network that uses MPLS switching for their network. I have worked primarily in frame-relay networks, with EIGRP as the routing protocol. I was just wondering...
I have a WRT54G router from LinkSys. Every now and then the router freezes and I have to reboot the router. Five seconds later I'm "in the air".
That's all fine, when I'm in the neighborhoo...
We are having intermittant but persistent network problems on a small LAN with a Cisco 2800 router as the edge device/firewall.
NETWORK OVERVIEW:
10 PC's, no servers, most unit hard-wi...
I am getting frequent error in the router log,
IP_VFR-4-FRAG_TABLE_OVERFLOW: FastEthernet0/1: the fragment table has reached its maximum threshold 16
Aslo sh verion shows "System retu...
I got a cisco switch to pratice with but router was configured before and I do not have username and passwordword. How can I reset this router to the default state?
I am setting up a small home network using my Verizon PCMCIA air card. I currently have that hooked up to my laptop at a docking station. We bought two new dell computers and a Linksys BEFSR...
I have Verizon FiOS service which came with an ActionTec router. I would like to REPLACE the FiOS router with a Wireless-N router with gigabit ethernet.
I can make the system work by plugg...
While trying to find a solution to a packet loss problem we are getting with our internet connection our ISP has asked us to change the MTU packet size on our router from the default value of ...
The wifi side of my router failed after running fine for several months. I was sent a replacement router. The setup cd wizard worked fine for the wired side. I can directly connect from a c...
I have a Cisco 1841 it says at boot time:
---
Readonly ROMMON initialized
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
---
Sending a break when the unit is powered on has no effect.
...
The facts:
- Connected to the wireless router I have a wired desktop pc and a wireless notebook;
- Only the desktop downloads torrents and play games, the notebook just surf the internet a...
Hi,
I am trying to get a new P2P T1 up and having a lot of trouble.
Can someone take a look at these configurations and tell me what I am doing wrong.
All the serial interfaces are status "...
I have a Cisco 3845 router with a 4 port t1 wic and a newly installed DS3 card. The 4 port wic shows up fine and I was able to see it by issuing the #card type T1 0 0 command. However the DS...
Hi,
Here's my situation.
I have 1 router (Speedtouch 716 WL), wired PC, 2 laptops (wireless), 1 PS3 (wireless).
Internal network is 10.0.0.x 255.255.255.0, Router internal address is ...
hello,
I've Linksys wireless router WRT54G thro which I want to block some specific web sites. In the access restriction I mentioned the URL, but still the web site are opening. How to block ...
I am trying to configure my built in DSL modem on my 1841 router. I have a single static address. I have entered my username and password with no problems but when I try and setup my static ad...
Hello,
I'm trying to setup a VPN tunnel from a Cisco 851 router.
Definition of problem is in attached pdf file.
LAN is 57.51.84.0/27 - I know these are public IP addresses but it is so.
...
Hello Experts.
We have a Cisco 877 Adsl Router.
I want to disable the following comand lines from the config.
1-ip forward-protocol nd
2-ip auth-proxy max-nodata-conns 3
3-ip admissio...
I have a Cisco 1841 it says at boot time:
---
Readonly ROMMON initialized
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
---
I have reviewed much documentation in particular I have read...
Question configuring Vlans on Cisco 3750 for AT&T Opt-E-Man Circuit
I am having trouble configuring (3) sites to the Opt-E-Man Circuit thru Cisco 3750 Metro switches.
AT&T is telling m...
Hello,
I want to disable Telnet on all my cisco switches and router and pix.
and enable SSH.
What is the easy way i can set this up???
Hi all,
Recently we had an infected workstation that was sending out spam. As a result we're on a couple of blackhole lists. To prevent this from happening again, I would like to block ou...
I have a rack of servers. One of the boxes is dedicated for a client service. I need to cap their speed. I know they should be on their own vlan. But for the time being, they're in the mix wit...
quick run down of what I have. Cable modem that goes to a sonicwall firewall, then to juniper ssg5, then to switches. My sonicwall does all of our DHCP / VPN traffic, and for now I would lik...
I am getting this message when I click a link in Outlook email. If I copy and paste this link in IE and it is working fine. I have IE verion 6 SP2 and Windows XP Pro SP2. This is work PC.
I c...
