I have a scope on my Dhcp server with the following Ip address 10.1.1.1 to 10.1.1.254. I now have more pc on my network. I would like to have a new ip scope on my dhcp server so that it will...
We have 2 vlans and need to have the DHCP server on one vlan ( 500 ) and the dhcp clients on a different vlan ( 200 ). Is there a way to forward the packets across the vlans ? We want the ...
I have an issue with windows 2003 server dhcp scope. I have two scopes 10.x.x.x and 192.x.x.x. When I run out of 10.x.x.x it should start giving out 192.x.x.x but it does not. IT just runs out...
How is a DHCP server registered in AD? One of my colleauges have enabled the DHCP service on a MAC server and that makes some problem on my network. He uninstalled the service on the MAC serve...
DCHP server assigning 169.x.x.x address to laptop with an intel pro/wireless 3945ABG card using a RangeMax 240 wireless router (wpnt834) that works fine with all other computers on the home ne...
I am running a network with redundant datacenters. I created a scheduled task to export all dhcp scopes from the primary datacenter to the secondary sites using netsh dhcp server commands. Thi...
we are running server 2003 R2 enterprise edition and we have multiple subnets on our network and we want to use DHCP. now i know i have to use DHCP relay agents to do this but my question is,...
I apologize if this has been hammered into the ground in previous topics... But this question is just a bit different.
I have a single subnet with 2 DCHP servers (Windows Serv2K3). They'r...
Hey guys!
Here is the situation: I have one 3COM 7757 with a 96Gb Fabric and (4) 10G Modules in it. It is connected to two stacks (3COM 3870's (2) 48pt + 24pt in each stack) and to two si...
We are running out of IP addresses and I am sifting through our DHCP leases. There are at least 100 ip addresses leased out "RAS". All of our servers are listed as having 10 RAS ip's, and seve...
I have a network setup with a DHCP server and all of the clients are set to dynamic. The network printers and servers are set to static ip addressess that are documented. I have one computer t...
This morning, I have 4 clients (running WinXP) out of 55 that can't ping the DHCP server (SBS 2003). All of the clients are pulling 169.*.*.* IP addresses. When I setup a static IP, all conn...
Hello
We have a LAN of more than 300 nodes and DHCP service is perfectly working for all of them.
but on one of the node DHCP is assiging IP beyond the defined scope and always assigning ...
I have a device in my network that has an IP address of x.x.x.x and I can not locate the device or know what kind of device it is. I'm trying to find out what device it is so that I can troubl...
We currently have one DHCP server in our environment and are deploying a 2nd with split scopes. We have a few questions re: implementing these, however. Were planning on excluding .1 - .50 ...
I am migrating from a Linux DHCP server to a Windows 2003 Server DHCP.
Our wireless network scope on the linux server requires that the MAC address be "authorized" (for a lack of better ter...
I need to make several DHCP reservations for a phone system and I am looking for a way to Export the Scope, add the new entries, then import the scope with the updated list.
I know in wind...
Please bear with me - I know there are similar questions here, but the details of this issue have me baffled. DHCP has ceased to function on one subnet of my network. The clients are getting...
I am running Windows XP. The system began taking an unusually long time to boot and when I do an IPCONFIG/Renew it takes 65 seconds versus 5 seconds on other computers connected to the same ...
I keep having a problem with my DHCP on my network. I am running DHCP on one of my server and it just stopped distributing IP addresses. If I use static everything is fine, routes, pings etc...
We are looking to create a backup DHCP server on a single subnet network. I set server1 to give out IPs in range 10.0.0.100 to 10.0.0.195 and server2 to give out 10.0.0.196 to 10.0.0.220. Is t...
Running DHCP server on a Windows 2003 Standard Edition server.
The issue I'm having is this...
Computer is configured and running in one VLAN that recieves an IP in one subnet. For examp...
Dear Experts:
We have a local area network. In the local area network (domain name "aqua") we have a Windows Server 2000 machine (named "kingfisher") working as both the DNS server and ...
I am running windows server 2003 standard ethernet network with 8 clients running xp pro. I have a netopia router/modem connected to the server. I just obtained a static (actually 5) IPs from ...
Three levels at three sites:
- DC.Root.Domain
- DC1.Child.Domain, DC2.Child.Domain
- DC.Site.Child.Domain
All Windows 2003 with ADI DNS
How would things be setup?
The current confi...
