asked on

Riverbed interfaces as unknown

For some reason, we are not seeing any traffic being optimized on our riverbed. The inpath interfaces are showing as UNKNOWN on both the lan0_0 and wan0_0 interfaces and no negotiated, even though all ends are set as auto/auto. I even tried setting the interfaces as duplex full and that didn't work.

Here is what the interfaces are shown as:

Interface wan0_0 state
Up: yes
Interface type: ethernet
Speed: UNKNOWN
Duplex: UNKNOWN
MTU: 1500
HW address: 00:0E:B6:28:A7:C5
Link: no

Interface lan0_0 state
Up: yes
Interface type: ethernet
Speed: UNKNOWN
Duplex: UNKNOWN
MTU: 1500
HW address: 00:0E:B6:28:A7:C4
Link: no

RX bytes: 0
RX packets: 0
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0

TX bytes: 0
TX packets: 0
TX discards: 0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0

Does anyknow know why the interfaces are down and no traffic is being optimized?

thanks,
LN

Suncore

Is Link State Propagation enabled ? - Try disabling, just as a troubleshooting measure - to see if one of the Steelhead ports come up.

Paula Wong

ASKER

There is an issue with the Riverbed appliance and we are using a different one.

Paula Wong

ASKER

I've requested that this question be closed as follows:

Accepted answer: 0 points for LateNaite's comment #a40304866

for the following reason:

We used a different appliance.

Paula Wong

ASKER

Have the answer to this question already.

Paula Wong

ASKER

Don't need it anymore.

Paula Wong

ASKER

Don't need it anymore.

ASKER CERTIFIED SOLUTION

Netminder

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Netminder

I've requested that this question be closed as follows:

Accepted answer: 0 points for Netminder's comment #a40316535

for the following reason:

Restarting closing for Asker.

Netminder
Senior Admin