|
[x]
Posted via EE Mobile
|
|
| Search, ask, and monitor your questions on the go with EE Mobile. Visit Experts Exchange from your mobile device and never be out of touch again. |
|
|
|
|
|
[x]
The Solution Rating System
|
|
| With so many solutions, how can you tell which solutions are most likely to help you and which ones are not? To provide you with a tool to use, we rate our solutions based on various elements that most accurately determine if a solution is a quality solution. To explain what factors affect the solution rating, here are the elements we take into consideration when formulating our solution rating. - The Grade of the Solution
- The Zone Rank of the Expert Providing the Solution
- The Number of Author and Expert Comments
- The Number of Experts Contributing
- The Feedback of the Community
Your Input Matters
Because of the way the system is set up, the most important variable in this equation is you. As a member of Experts Exchange, you are able to cast your vote on the quality of the solutions in regard to how complete, accurate, helpful and easy to understand each solution is. When you provide your feedback, each rating is adjusted accordingly. So, if you see a solution that has a poor rating that you think is a good solution, let us know by rating it. As you do, the rating will be adjusted and will become more accurate for other members of our site. If you have any suggestions that you would like to make for our rating system, please ask a question in the Suggestions Zone of Community Support. Thank you! |
|
|
|
|
Asked by occs07 in Voice Over IP, Network Routers
I have setup CME 4.1 with a cisco 7940 ip phone in dual-line mode. I am using vonage as my PSTN line which connects to my FX0 card on voice-port 0/0. When I am on the phone I hear the beeping noise from call waiting but do not see the indicator on my phone nor do I see caller-id although caller-id works when the phone is not busy. I've been reading through Cisco and google and have tried many ways for configuring the ephone-dns but none seem to work.
The phone setup is as follows: Since the 7940 is a 2 button phone I assigned the first button to my extension and the 2nd button to the main line extension. The setup I used for call waiting was:
button 1:3 2c1,2 button 1 gets ext. 1003 and button 2 gets ext. 1001 and 1003. This still did not work. Any help would be greatly appreciated.
20091111-EE-VQP-91 - Hierarchy / EE_QW_3_20080625
