Cisco FXS card. Attached phone does not ring

Hi

I have installed an 4-fxs/did card into a cisco 2801. I have attached a phone to one of the interfaces and can make calls on that phone to IP phones in the office however when I try to call the phone it doesnt ring but I do hear ringing on the phone I call from.

The gateway talks to call manager via H.323 and I have setup a route pattern on call manager for the number I want to assign to the analog phone (354822) This seems to be working as I can see the following when I call that number and have debug vpm all running:

*Jun 12 11:13:47.203: htsp_timer_stop3 htsp_setup_req
*Jun 12 11:13:47.203: htsp_process_event: [0/2/1, FXSLS_ONHOOK, E_HTSP_SETUP_REQ]fxsls_onhook_setup
*Jun 12 11:13:47.203: TGRM: reg_invoke_tgrm_call_update(0, 2, 1, 65535, 1, TGRM_CALL_BUSY, TGRM_CALL_VOICE, TGRM_DIRECTION_OUT)htsp_progress
*Jun 12 11:13:47.203: [0/2/1] set signal state = 0x0 timestamp = 0
*Jun 12 11:13:47.203: dsp_set_sig_state: [0/2/1] packet_len=12 channel_id=136 packet_id=39 state=0x0 timestamp=0x0
*Jun 12 11:13:47.211: htsp_call_bridged invoked
*Jun 12 11:13:47.459: flex_dsprm_forking_mixing_support:
*Jun 12 11:13:47.459: mars_flex_dsprm_current_codec_comp:DSP:4 FLEX Complexity Codec
*Jun 12 11:13:47.459:  DSPWARE Version < 3.0 actual is 23.8.0
*Jun 12 11:13:47.459: htsp_process_event: [0/2/1, FXSLS_WAIT_OFFHOOK, E_HTSP_VOICE_CUT_THROUGH]fxsls_waitoff_voice
*Jun 12 11:14:05.111: htsp_timer_stop3 htsp_release_req: cause 16, no_onhook 0
*Jun 12 11:14:05.139: htsp_process_event: [0/2/1, FXSLS_WAIT_OFFHOOK, E_HTSP_RELEASE_REQ]fxsls_waitoff_release
*Jun 12 11:14:05.139: [0/2/1] set signal state = 0x4 timestamp = 0
*Jun 12 11:14:05.139: dsp_set_sig_state: [0/2/1] packet_len=12 channel_id=136 packet_id=39 state=0x4 timestamp=0x0
*Jun 12 11:14:05.143: TGRM: reg_invoke_tgrm_call_update(0, 2, 1, 65535, 1, TGRM_CALL_IDLE, TGRM_CALL_VOICE, TGRM_DIRECTION_OUT)
*Jun 12 11:14:05.143: flex_dsprm_close_cleanup

Here is the current config of the gateway:


!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname dbl-mit-g01
!
boot-start-marker
boot system flash:c2801-spservicesk9-mz.124-22.T.bin
boot-end-marker
!
logging message-counter syslog
no logging buffered
no logging console
enable secret 5 $1$Ug8r$jIunEXVA24fWe3UkZpBJ50
!
aaa new-model
!
!
aaa authentication login SAFETY local enable
aaa authentication login RSA group radius local
!
!
aaa session-id common
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-select 1 BRI0/0/0
network-clock-select 2 BRI0/0/1
network-clock-select 3 BRI0/1/0
network-clock-select 4 BRI0/1/1
dot11 syslog
ip source-route
!
!
!
!
ip cef
ip name-server 10.96.68.130
ip name-server 10.96.73.150
no ipv6 cef
multilink bundle-name authenticated
!
!
!
!
isdn switch-type basic-net3
!
!
voice rtp send-recv
!
voice service pots
!
voice service voip
 h323
 modem passthrough nse codec g711alaw
!
!
voice class codec 1
 codec preference 1 g711ulaw
 codec preference 2 g729r8
 codec preference 3 g711alaw
!
!
!
!
voice class h323 1
  h225 timeout tcp establish 3
!
!
!
!
!
!
!
!
!
!
!
voice-card 0
 dsp services dspfarm
 no local-bypass
!
!
application
 global
  service alternate DEFAULT
 !
!
!
!
!
!
username admin password 7 00071B1454555B1216311F
archive
 log config
  hidekeys
!
!
!
!
!
!
interface FastEthernet0/0
 ip address 10.96.196.201 255.255.255.0
 duplex auto
 speed auto
 h323-gateway voip interface
 h323-gateway voip bind srcaddr 10.96.196.201
!
interface FastEthernet0/1
 no ip address
 shutdown
 duplex auto
 speed auto
!
interface BRI0/0/0
 no ip address
 isdn switch-type basic-net3
 isdn point-to-point-setup
 isdn incoming-voice voice
 isdn static-tei 0
!
interface BRI0/0/1
 no ip address
 isdn switch-type basic-net3
 isdn point-to-point-setup
 isdn incoming-voice voice
 isdn static-tei 0
!
interface BRI0/1/0
 no ip address
 isdn switch-type basic-net3
 isdn point-to-point-setup
 isdn incoming-voice voice
 isdn static-tei 0
!
interface BRI0/1/1
 no ip address
 isdn switch-type basic-net3
 isdn point-to-point-setup
 isdn incoming-voice voice
 isdn static-tei 0
!
no ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 10.96.196.254
ip http server
no ip http secure-server
!
!
!
snmp-server community tw3nty4ourKW8 RO
!
!
!
radius-server host 10.96.169.188 auth-port 1645 acct-port 1646
radius-server host 10.96.68.188 auth-port 1645 acct-port 1646
radius-server host 10.96.73.188 auth-port 1645 acct-port 1646
radius-server key 7 141A431F1F117B78313A632571
!
control-plane
!
!
!
voice-port 0/0/0
 compand-type a-law
 cptone IE
!
voice-port 0/0/1
 compand-type a-law
 cptone IE
!
voice-port 0/1/0
 compand-type a-law
 cptone IE
!
voice-port 0/1/1
 compand-type a-law
 cptone IE
!
voice-port 0/2/0
!
voice-port 0/2/1
 cptone IE
!
voice-port 0/2/2
!
voice-port 0/2/3
!
ccm-manager fax protocol cisco
!
mgcp fax t38 ecm
!
!
!
dial-peer voice 1 pots
 preference 1
 destination-pattern 9T
 direct-inward-dial
 port 0/0/0
!
dial-peer voice 2 pots
 destination-pattern 9T
 progress_ind alert enable 8
 direct-inward-dial
 port 0/0/1
!
dial-peer voice 3 pots
 destination-pattern 9T
 progress_ind alert enable 8
 direct-inward-dial
 port 0/1/0
!
dial-peer voice 4 pots
 destination-pattern 9T
 progress_ind alert enable 8
 direct-inward-dial
 port 0/1/1
!
dial-peer voice 11 voip
 destination-pattern 354...
 progress_ind setup enable 3
 voice-class codec 1
 voice-class h323 1
 session target ipv4:10.96.79.133
 dtmf-relay h245-alphanumeric
 no vad
!
dial-peer voice 12 voip
 preference 1
 destination-pattern 354...
 progress_ind setup enable 3
 voice-class codec 1
 voice-class h323 1
 session target ipv4:10.96.79.132
 dtmf-relay h245-alphanumeric
 no vad
!
dial-peer voice 13 voip
 preference 2
 destination-pattern 354...
 progress_ind setup enable 3
 voice-class codec 1
 voice-class h323 1
 session target ipv4:10.96.73.2
 dtmf-relay h245-alphanumeric
 no vad
!
dial-peer voice 100 voip
 voice-class codec 1
 incoming called-number .
 no vad
!
dial-peer voice 5 pots
 destination-pattern 354822
 port 0/2/1
!
!
num-exp 4... 354...
num-exp 0152 354810
!
call-manager-fallback
 max-conferences 4 gain -6
 transfer-system full-blind
 ip source-address 10.96.196.201 port 2000
 max-ephones 30
 max-dn 52
 system message primary System is in backup mode
 time-zone 22
 time-format 24
 date-format dd-mm-yy
!
banner exec  

You are logged into dbl-mit-g01

Cisco 2801

 
banner login  
Please enter your username and password below

Do not attempt to logon unless authorized!  
banner motd  

MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM

 
!
line con 0
 login authentication SAFETY
line aux 0
line vty 0 4
 exec-timeout 30 0
 login authentication RSA
 transport input telnet
 transport output telnet
line vty 5 15
 exec-timeout 30 0
 login authentication RSA
!
scheduler allocate 20000 1000
end


Any ideas why this wont ring?

Thanks!
Systems