|
[x]
Posted via EE Mobile
|
|
| Search, ask, and monitor your questions on the go with EE Mobile. Visit Experts Exchange from your mobile device and never be out of touch again. |
|
|
|
|
|
[x]
The Solution Rating System
|
|
| With so many solutions, how can you tell which solutions are most likely to help you and which ones are not? To provide you with a tool to use, we rate our solutions based on various elements that most accurately determine if a solution is a quality solution. To explain what factors affect the solution rating, here are the elements we take into consideration when formulating our solution rating. - The Grade of the Solution
- The Zone Rank of the Expert Providing the Solution
- The Number of Author and Expert Comments
- The Number of Experts Contributing
- The Feedback of the Community
Your Input Matters Because of the way the system is set up, the most important variable in this equation is you. As a member of Experts Exchange, you are able to cast your vote on the quality of the solutions in regard to how complete, accurate, helpful and easy to understand each solution is. When you provide your feedback, each rating is adjusted accordingly. So, if you see a solution that has a poor rating that you think is a good solution, let us know by rating it. As you do, the rating will be adjusted and will become more accurate for other members of our site. If you have any suggestions that you would like to make for our rating system, please ask a question in the Suggestions Zone of Community Support. Thank you! |
|
|
|
|
Asked by kandallu in Global System for Mobile Communications (GSM), Visual Basic Programming, Short Message Service
Dear Experts,
I am using Multitech Modem to send automatically triggered sms from database. I use the MSComm component in vb6 exe to send SMS with AT commands. I have provided a sleep timeout of 15 sec between each sms. This is to ensure that the message has been successfully sent before the next sms could be sent from queue. Everything seems to be fine but occassionally the modem gets stuck up which needs a power OFF and ON reset of the modem. All i could understand from this forum is that the application has to get the modem response before proceeding with the sending of SMS. I have three questions
1. How to check the signal strength using AT command? Can i get the value so that i can store it into a log.
2. How to check the SMS modem response after a message has been triggered?
3. Any AT command to reset the modem (i.e. Power OFF and the ON).
I have very little knowledge and working experience in vb6 application development and i have developed this small application. Now i require some add-ons on the above mentioned lines. I would deeply appreciate if experts could respond to my queries with code snippets.
Masha
20091118-EE-VQP-93 - Hierarchy / EE_QW_3_20080625