How to setup IE connection from ISP

Your config should be as follows:


PC's - their dhcp assigned IPs, subnet masks and the default gateway should be your router/proxy.  Dns should be your domain controller as a primary, your proxy/router as a secondary.

Proxy/router - Should have static IP on internal LAN with matching subnet and gateway point out to the web.  The DNS should be itself for primary and ISP for secondary.

Domain controller should have static ip, SNM and default gateway of router/proxy.  DNS01 should be self and DNS02 should be proxy/router.

Pearl, When I setup the server for the last ISP change I only thought i setup the (2) DNS primary and secondary IP's

Then sorry to have to say this, but the setup you have is wrong.

I know its a kick in the balls to hear that.  I'd be pissed if someone said it about my networks too, but unfortunately, what I've stated above is the standardised and most efficient way of setting up a DNS based domain network.

Is there anything i can do to help you get your network setup more efficiently such like or anything else you want me to help with?

it seems as if Point-In-Cyberspace is giving me the correct information

it will work providing your DC is also acting proxy and primary DNS server, but in most networks this isnt the case.  Best of luck either way though and if it doesnt work, ask away :)

The correct way to set up your gateway and DNS is so that all your machines in the domain, and that includes the server itself, use the IP address of the server as the ONE AND ONLY DNS server, That is the IP address of the SBS server should be specified as the "Preferred" DNS server, either in the TCP/IP settings and/or as in the DHCP scope options - the wizard will normally take care of this for you.

The ONLY place the ISPs DNS servers should appear is as FORWARDERS, they should not appear anywhere else (and certianly not as either "Preferred" or "Alternate" DNS servers for any machine on your domain - or it WILL cause issues) - again the wizard will normally take care of this.

KCTS, after looking at my hardware. my old system went through was hooked up this way. the main signal from my ISP was sent through a router then to my server.

Old system with ISP (router included): in the wizard i have set the following:

My server uses: A local router device with an IP address
I input both my prefered DNS and Alternate DNS this is from our ISP
The local I{P address of the router is 192.168.X.X
ISP Network connection: Network Connection
Local Network connection: Server Local Area connection

everything else is left the same


In the new connection (this is why im asking this question) what do I need to configure for my new ISP?

I'll make an example to better clarify what you have to check/modify.
Suite addresses to your REAL network.


Router: 192.168.1.1
Server: 192.168.1.100
Other computers: 192.168.1.1xx
Isp dns server1: 123.45.67.89
Isp dns server1: 123.45.67.90


In the server:
Ip properties of network card:
default gateway: 192.168.1.1 (the router)
First Dns server: 192.168.1.100 (the server itself)
Second dns server (leave blank)

In server Dns service management console:
right click server name
properties
add in the dns forwarders the Dns addresses the Isp gave you. (123.45.67.89 and 123.45.67.90)
remove previous dns forwarder addresses.

In server Dhcp service config
Scope 192.168.1.0
Exclusions: 192.168.1.1 192.168.1.100
Scope options: Dns server: 192.168.1.100
Gateway: 192.168.1.1

That's all. You can use the wizard but in this way you will understand what you are doing.

I was able to configure the SERVER using the wizard and the correct ISP however when I looked closer at everything I noticed that I didn;t get any emails or wasn;t able to connect to the RWW or Outlook web access


Any suggestion?

KCTS, I was able to run through the wzard and plug my ISP main line into a switch then into a router then back into my SERVER. When i inputed all the correct information provided by my ISP (both primary and alternate IP) I was able to get online, how ever I could not get my outlook mail (only internal mail came in) and I wasn;t able to get to my VPN or OWA...

Regarding the Mail issue, because you changed ISPs, you may have to call them and have them create MX records for you on their DNS server so mail will flow to your Mail Server...  (I have been through this before)

FE

my new ISP says they dont handle this...what else can I do?