grantballantyne
asked on
Dell Poweredge 1800 setup
Dear Experts
I have a dell poweredge 1800 and i have put brand new sata hard disks into it.
My problem is that it does not give me an option to press F6 to allow me to load the cerc drivers.
Can anyone assist?
Thanks
I have a dell poweredge 1800 and i have put brand new sata hard disks into it.
My problem is that it does not give me an option to press F6 to allow me to load the cerc drivers.
Can anyone assist?
Thanks
On the Windows setup screen, when it first begins at the bottom of that screen is it now show press F6? If not, when windows starts the installation start pressing F6. It should then get to the screen you need.
You should be able to press F6 even if it does not offer the option if you just start mashing the key once it starts to boot from the disc.
Alternatively, you can boot off Dell's "Build and Update Utility" disk and it should pre-stage the drivers for you as well as all the other drivers you'll need and the disagnostic partition as well.
It should be here: http://tinyurl.com/3cu47y8 or http://tinyurl.com/6455v86
Alternatively, you can boot off Dell's "Build and Update Utility" disk and it should pre-stage the drivers for you as well as all the other drivers you'll need and the disagnostic partition as well.
It should be here: http://tinyurl.com/3cu47y8 or http://tinyurl.com/6455v86
If you need a link for the Dell installation cd.
http://support.dell.com/support/downloads/download.aspx?c=us&cs=04&l=en&s=bsd&releaseid=R273104&SystemID=PWE_1800&servicetag=&os=WNET&osl=en&deviceid=24135&devlib=0&typecnt=0&vercnt=2&catid=-1&impid=-1&formatcnt=0&libid=36&typeid=-1&dateid=-1&formatid=-1&source=-1&fileid=403482
http://support.dell.com/support/downloads/download.aspx?c=us&cs=04&l=en&s=bsd&releaseid=R273104&SystemID=PWE_1800&servicetag=&os=WNET&osl=en&deviceid=24135&devlib=0&typecnt=0&vercnt=2&catid=-1&impid=-1&formatcnt=0&libid=36&typeid=-1&dateid=-1&formatid=-1&source=-1&fileid=403482
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.