prinand
asked on
setup network for new Solaris 8 system on a Blade 1000
I have just received a new solaris system with solaris 8 pre-installed. However, the network is not setup. There is not hostname.le0 or wharever extension, if I do a ifconfig -a I only see the localhost.
how do I configure the system that is starts using a fixed IP address, and that it starts the network card. currently I have no clue how the card is named or should be named (le0, hme0 etc ??) I know if I install the system from scratch it will be done for me, but there must be a shorter way to have the network activated and setup...
any suggestions how ?
how do I configure the system that is starts using a fixed IP address, and that it starts the network card. currently I have no clue how the card is named or should be named (le0, hme0 etc ??) I know if I install the system from scratch it will be done for me, but there must be a shorter way to have the network activated and setup...
any suggestions how ?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Glad to be of help
No comment has been added lately, so it's time to clean up this TA.
I will leave a recommendation in the Cleanup topic area that this question is:
Answered by yokel
Please leave any comments here within the next four days.
PLEASE DO NOT ACCEPT THIS COMMENT AS AN ANSWER!
liddler
EE Cleanup Volunteer
I will leave a recommendation in the Cleanup topic area that this question is:
Answered by yokel
Please leave any comments here within the next four days.
PLEASE DO NOT ACCEPT THIS COMMENT AS AN ANSWER!
liddler
EE Cleanup Volunteer
ASKER