I'm sure that this is all blatently simple and I'm just missing something... but here's the scenario.
Private Point-to-Point Link
Router A
Cisco 2621XM
VWIC-2MFT-T1
Controller T1 0/0
channel-group 0 timeslots 1-24 speed 64
clock source internal
linecode b8zs
framing esf
Serial 0/0:0
ip address A.A.A.A B.B.B.B
encapsulation ppp
clock rate 154000
Router B
Cisco 1721
Serial 0
ip address A.A.A.A B.B.B.B
encap ppp
service-module t1 clock source line
service-module t1 linecode b8zs
service-module t1 framing esf
My problem is that I am getting a Serial 0/0:0 is up, line protocol is down.
I'm sure its a simple thing I'm missing, but its a bit frustrating... If anyone has any quick suggestions, I'd love to hear them!
Thnx in advance!
Start Free Trial
