HI Team,
My Question is related to CISCO 5520, Software Version 8.0(3) and ASDm Version 6.0(3)
I am using GE0/0 Interface as outside interface, Because i have three different physical interface coming from out side. I created three subinterfaces on outside interface named CIC, VPN and NET all set security level 0, Inside Network is 10.10.10.0/24,
Outside =G0/0 (Does not have ip address
CIC =G0/0.1 (10.1.1.3)
VPN=G0/0.2 (10.10.11.1)
NET=G0/0.3 (172.16.1.1)
I had a Layer 2 Switch. So i created 3 VLANS on layer2 switch (Netgear724T) and created two trunk ports. Trunk port is the member of all three VLANS. Now i have plugged my physical outside interface (which is actually all three sub interfaces) into trunk port of the switch.
For testing purpose i have allowed all traffic on each subinterafce. but when i try to ping from any of the out side VLAN i can not even ping outside subinterafces IPs.
Am i doing a findamental mistake by using Layer2 switch for Vlans ? i do not have layer 3 switch.
Also i have two identical ASA5520 with same software versionand ev tihing is identical. I have als oconfigured failover. but i get following warning message as well
"WARNING: This command will not take effect until interface 'outside' has been as
signed an IP address
End configuration replication from mate.
"
DO i have to put any ip address onout side ?
Please Advise
Start Free Trial
