I have a PIX 515e unrestricted license in a production environment. I noticed when I run the show ver command i get the following output:
helm-pix01config# show ver
Cisco PIX Firewall Version 6.3(3)
Cisco PIX Device Manager Version 3.0(1)
Compiled on Wed 13-Aug-03 13:55 by morlee
helm-pix01config up 91 days 0 hours
Hardware: PIX-515E, 64 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
Encryption hardware device : Crypto5823 (revision 0x1)
0: ethernet0: address is 0011.5cfa.2a52, irq 10
1: ethernet1: address is 0011.5cfa.2a53, irq 11
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES-AES: Disabled
Maximum Physical Interfaces: 6
Maximum Interfaces: 10
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
This PIX has an Unrestricted (UR) license.
Serial Number: xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxx
x
Running Activation Key: xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxx
xxxxxx
Configuration last modified by enable_15 at 11:06:14.432 UTC Mon Aug 21 2006
helm-pix01config#
We are using a VLAN configuration for numerous clients so that thier diffenent environments have some sepearation. The Maximum Interface 10 statement in the PIX show ver command leads me to believe I can have only a limited number of VLANs since each VLAN is defined as a logical interface. Is this correct and if so how would I enable the ability to have more VLANs in the future?
So far I have 8 VLANS (including the management VLAN) as logical interfaces and then 2 physical interfaces.
Jude
Start Free Trial