Hello, I working in an environment that has its own seperate network. The network consists of several Cisco 3750 switches. The network also has some devices on it that send out Multicast traff...
Experts,
We have an HP ProCurve 5412 swtich and 3 Cisco 2800 routers. We also have a main branch which needs to supply non-employees internet access from time to time. Our main brach is o...
http://www.experts-exchange.com/Networking/Network_Management/Network_Design_and_Methodology/Q_23257886.html
This question is a small continuation of the above completed thread. If I do every...
Hi friends !
I want to implement true Gigabit network. But I have some doubts in this concern.
You see, I am going to implement a new network with 300 PCs (Desktops). All of them will ha...
I`ve just started to work with Nortel switches. Have always been working with cisco. When I created a new vlan on a cisco router I created a vlan and assigned a ip address and mask. With norte...
Hi Guys,
I am going to be setting up Vlans on one of the networks (5 wireless internet towers) and ran into a little problem with the ip addresses.
I have the vlans as follows:
vlan2: ...
We have two offices that need to communicate in real time across our WAN (created from an encrypted VPN between the two office firewalls). As you know, sharing files across the WAN doesn't wo...
Hi Experts,
I'm setting up a new branch office very similar to the one shown in the attached diagram, and wanted to run it by you guys before buying any equipment.
My two questions are:...
I need to figure out how to design and number a mixed 100/1000 MB client environment.
The mix:
" 28 G3 PPC clients only have 100 MB capable nics.
" 15 G4 PPC clients or so have 1000m...
hi,
i'm trying to track down a networking expert who is familiar with cisco packet tracer.
i have set up a network with various subnets and routers and i am having trouble getting 2 rout...
Hi I have created a vlan 200 on my 3750 core switch. All settings are as other Vlans but my new one reads a status of Down instead of up. Am I amissing something about making this Vlan active...
I am currently at a colo facility with many T1 circuits coming into my cage. My provider wants to replace all of them a single DS3 crossconnect with each T1 on its own channel. I am actually...
if you have a router with two interfaces LAN and WAN (cloud)
Can i create an subinterface on the WAN interface then assign a GRE tunnel to my subinterface (the tunnel goes to another site l...
Hello all,
I have 1 Cisco 1841 with 4 Fastethernet and one serial port, 3 subnets, and one LAN segment.
Requirements:
- I'd like to have a network utilizing the 3 subnets.
- Each of my...
Hello Experts,
I would like to troubleshoot the connectivity issues I have been having with my Telco Provider..I have a 1841 Cisco router in both facilities and cisco 2950's on each end as ...
We have a 2mb private line between our two offices and a Cisco 1700 series router at either end. It's a little slow these days and was looking for some advice as to how to minimise unncessar...
You have been been given the task of creating a WAN link between your LAN and a new building located 2 miles down the road. The existing LAN has 5 departments (Wholesale, Corporate, Warehouse,...
I need to be able to create a VLAN for our new IP phone system as we do not have enought IP's in the LAN to assign to all the handsets. I have a netgear FSM7328PS switch which is layer 3. I ne...
Hello all,
I read the White Paper, Enterprise QoS Solution Reference Network Design, and I understand the concept of classifying, marking, policing, and scheduling. However, I am still have...
I have some new servers, which have NICs in them capable of load balancing... unfortunately, I am fairly new to this topic. I've read through the documentation, however I seem to be running i...
I am having a bit of mental block. Can different subnetted ip's run over the same physical segment. I am looking at putting my computer lab on a different subnet than the rest of my organiza...
Please assist in our decision making progress.
We are shortly to move into a new HQ. We have the Cisco kit for that building, consisting of a 3750G stack in the data centre, and a 24 port ...
We have a LAN with the following current topology:
SERVER cabinet -->3x PowerConnect switches on cabinet-->patch panel-->25x workstations << all CAT5e>> (building A)
...
Hello,
I have a t1 connection with 5 public IP addresses. I have 2 LAN's internally, one is for a PBX/IP phone system and one is for computers, printers etc. I need help connecting my equip...
hi all,
we currently have a 255.255.255.0 network (192.168.0.0) meaning - up to 254 ip addersses.
we also have an "atelis" ip telephony system , meaning that our phone lines also take ip a...
