jwmillerill
asked on
Exchange Pre-Deployment Analyzer question
Okay this is what is going on. I have run the ePDA and dealt with all Critical issues and a few of the Moderate issues (Yellow sign with an exclamation). The few Moderate issues I have left to deal with I have no clue how to resolve. Both of them are as following:
Exchange Development Kit (EDK) connector found in topology
Exchange Development Kit (EDK) connector 'FAXport_Exchange_Connecto r' was found in the organization. Exchange Server 2010 does not support EDK connectors. This connector will need to remain on existing Exchange 2003 servers.
Non-standard address space found
A non-standard address space of 'FAX:@******.******.com' was found on recipient policy 'Delete Sent Items'. Contact your vendor to obtain a proxy address generator DLL that is compatible with Exchange Server 2010.
How can I remove/resolve these issues before continuing with the installation of Exchange Server 2010 into our environment? Googling any of these issues does not bring back any solid leads.
Exchange Development Kit (EDK) connector found in topology
Exchange Development Kit (EDK) connector 'FAXport_Exchange_Connecto
Non-standard address space found
A non-standard address space of 'FAX:@******.******.com' was found on recipient policy 'Delete Sent Items'. Contact your vendor to obtain a proxy address generator DLL that is compatible with Exchange Server 2010.
How can I remove/resolve these issues before continuing with the installation of Exchange Server 2010 into our environment? Googling any of these issues does not bring back any solid leads.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Would have liked to know how to remove the references within ePDA that mentioned all the Non-standard address spaces as I still see those but regardless as mentioned I can install without removing these.
ASKER
If I wanted to clean up Active Directory and remove these entries how would I go about doing that? Is it not better to clean out what is not being used with AD instead of letting it linger?