Hello everybody,
Since two hours i'm trying to get the Windows FLP Edition to work on my ESX 3.5.0 in a Virtual Machine. I used several diffrent settings. I can start the Setup but after th...
We have attached one of the ESX server's physical NICs to a Cisco SPAN Destination port. We want to set up a virtual Windows machine to run WireShark and capture the traffic on the Cisco SPAN ...
I just installed the free ESXi server and would like to import my old machines that were running in VMware Workstation as well as the free VMServer. From I can see it doesn't mention that I ca...
Hi,
We are looking to put a single ESX 3.5 server in ourenviorment. Mostl lkely a Dell PowerEdge 2950 III.
Usually I get 5 hard drives in the servers we get. 2 set as RAID 1 (mirroring) a...
I have a windows 2008 guest running on esx 3.5.
I am running a dell perc 5 i controller card. I am not able to get the dell server admin or lsi megaraid admin utility to detect the controll...
I have a Dell PowerEdge 2900III. I just created a new Vm and inserted my windows 2003 into my vmware server. When I power on the vm it goes right to trying to boot from the network and never t...
Hi Experts,
I'm trying to configure VMWare ESX 3.5 to connect to Openfiler iSCSI storage with redundant NICs on both machines. I'm running the SAN through a Gigabit switch, without a router...
Hi a Vmware image was unresponsive i.e. couldn't rdp console or even through Vmware itself. so I powered off the image and powered back on and got "the following file is missing or corrupt sys...
Hi,
We've just installed Redhat Linux server 5.1 on VMWare ESX server & the
VMWare host boots up on the Linux.
However, the console kept giving "link up/down" - don't know which NIC is ...
I would like to understand the configuration and the terminology used in VMware:
1-after installing ESX server on the local machine, I will have to assign IP address to Virtual console othe...
We are going to have a 2003 server running VM Ware server. If we have 3 virutal machines running on this (Exchange 2007, Sharepoint, and BES). We want to have a backup of the virtual machine...
I'm new to VMware Server and while playing around with an installation on a PowerEdge 2500 I screwed up the settings that the default wizard makes when setting up virtual servers for bridged n...
Hi. I'm installing VMWare on a single server that has two QLogic HBAs attached to a HP MSA 1000 SAN. This is the only server that will be connected to the SAN.
I've created a LUN to store m...
I Am trying to uninstall vmware server of my machine after an unsuccessful install, while running the perl script to uninstall the software i was presented with the following error message:-
...
Hello,
I have a XP Pro guest machine running under the SCSI HD type in Fusion. Due to the specific requirements of an application, the Windows "Enable write caching on disk" setting must ...
Hi Guys.
I'm about to order a new server barebones that has dual Marvell PHY 88E1121 NICs. We may wish to run ESX 3.5 or 3i in the future (we are running VMware's free server product at the...
I am running VMware ESXi and on a Dell Poweredge 1900. I have an onboard SATA controller that has 1 drive connected to it. This is where ESXi resides. I also have a PERC 5/i RAID controller...
I have set up a Dell PowerEdge 2500 as a test server for "learning" to use VMware. The Dell PE2500 has Windows 2003 installed and the VMware installation includes four separate Windows 2003 in...
I have a VMware ESXi server that has 2 pNICs, one which is plugged into pSwitch that has a VLAN for the DMZ. The other NIC is plugged into the same pSwitch in a different VLAN for the LAN. My ...
i am running windows 2003 on vmware workstation 6 and it was working fine till now when i try to run the vmware mach. it gives error
"Cannot open the disk 'G:\Virtual Mach\Windows Server ...
I installed backup exec agent on ESX server but it's not seeing the VMFS volume. I followed the following procedure
"export /vmfs/vmhba0:0:0:8 as local password vmware"
after reconfigu...
hi all,
i want to configure database server (sql 2005 on windows server 2003)on vm and access it throgh all client machine on my physical network. can any one tell me the whole network seeti...
I want to install Server 2008, 64-bit on a server (so that I can address 32gb or ram).
Can I install VMWare Workstation 6 on this machine?
All the guests will be 32-bit.
I've read her...
My main operating system is windows xp sp2
I installed vmware workstation 5, and installed in it solaris 10 from sun,
my problem that i can't connect to the internet from this solaris hosted...
I am fairly new with VMWare and no nothing really about Linux - please do not shoot me but I am a Windows man and need instructions so simple that even a Windows guru can follow . . .
I h...
