kastro
asked on
esxi 5.5
i am having 8 esxi host in a cluster on vsphere 5.5 .one of the Esxi host is giving the following error after reboot
"Associated host profile contain network policy setting that cannot be applied to the the Host"
please help .....
please view the attached file for error details
esxi-image.png
"Associated host profile contain network policy setting that cannot be applied to the the Host"
please help .....
please view the attached file for error details
esxi-image.png
ASKER
how can i check that all host have same network interfaces
ASKER
as all the host are using the same networking i just rebooted this server as the host was running on flash and i just plug out and plug in the flash ,and this error came out.
please suggest the possible solution in detail
please suggest the possible solution in detail
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
i am attaching the image for network adapters and networking of my hosts.Please view and suggest the solution
esxi1-network-adapters.png
esxi1-networking.png
esxi2-network-adapters.png
esxi2-networking.png
esxi-3-network-adapters.png
esxi3-networking.png
esxi1-network-adapters.png
esxi1-networking.png
esxi2-network-adapters.png
esxi2-networking.png
esxi-3-network-adapters.png
esxi3-networking.png
ASKER
did you find any solution for this
ASKER
any update !!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!! !!!!!!!
ASKER
i restarted my esxi host again but now it did not get the image profile............
Are you using Enterprise version or greater? If so with 8+ host you should use vDistributed Switch to make sure you networking is uniform for all host and controlled from one location only.
Are all server the same, make , model, driver and firmware levels?
Are all server the same, make , model, driver and firmware levels?
ASKER
no 4 servers are running on CISCO ucs AND REMAINING ON hp
ASKER
I've requested that this question be closed as follows:
Accepted answer: 0 points for ayazabbasi's comment #a39844485
for the following reason:
as i am expert
Accepted answer: 0 points for ayazabbasi's comment #a39844485
for the following reason:
as i am expert
It would seem it cannot apply a Host Profile to a Host, because networking has been defined differently.
e.g. Management Network is vmnic1, not vmnic0.