Link to home
Start Free TrialLog in
Avatar of mtthompsons
mtthompsons

asked on

Junos pulse when connected does not allow to access internet

Junos pulse when connected does not allow to access internet
When i connect via the Junos Pulse VPN client and take a session then internet on my local system does not.

I have a broadbard connected and only when my VPN is connected my browser fails to open any pages.

Any tweeks?
ASKER CERTIFIED SOLUTION
Avatar of btan
btan
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of bbao
bbao
Flag of Australia image
the common cause of the symptom is the option 'use the remote server as the default gateway' is checked in VPN configuration and the remote site does not allow internet access for VPN client.

make sure the above option is unchecked and see what happens.
Avatar of btan
btan
also good to note Juniper Networks VPN Tunneling adapter (Network Connect or Junos Pulse) default gateway is blank or 0.0.0.0 on Windows client, see the kb details here

When you have disabled Split Tunneling, the Default Gateway is set to your VPN Tunneling IP since all network traffic from the client should go through the tunnel. In Windows XP, VPN Tunneling routes are added with a lower metric (the route with the lowest metric is the one which will be used), but in Vista/7 the local routes are removed completely to ensure all traffic is routed through the VPN tunnel.  (See KB17354 for more information.) The Default Gateway is also set to your VPN Tunneling IP when you have chosen Allow access to local subnet, but SA will preserve the route on the client retaining access to local resources such as printers.
Avatar of mtthompsons
mtthompsons

ASKER

Thank you all. Is there a direct solution for this?
Like a proven reason the internet does not work and steps to have it enabled even when connected via VPN
Avatar of btan
btan
http://kb.juniper.net/InfoCenter/index?page=content&id=KB9306

Pls see above for troubleshooting guide from Juniper. You will need to share any error code or troubleshooting else it will be difficult to isolate. The a/m are common configuratiin thta may lead this symptoms.