Hai,
I am facing a problem in 2821 version 12.4(3d), release software (fc3). When i tried to configure the site to site vpn, the commands are not accepting and i was checked with the help file i...
http://www.experts-exchange.com/Networking/Misc/Q_21960613.html
I need assistance in bring up a VIC-2FXO is a 2821 router.
I can see the card recognized in the show diag screen
Thanks
WIC Slot 0:
FXO Voice daughter card (2 port)
WIC ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_22755952.html
How do I configure a Cisco 2800 router to Verizon via cisco's serial 0/0/0 T1 CSU/DSU interface--
Thanks!
Here's my current config:
===
Building configuration...
Current configuratio...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23178804.html
Hi i have to Cisco 2821 routers, the are connected together with both a serial cable and an Ethernet cable in their gigabit ports.
on router A i have the network 172.16.128.0 255.255.240.0, and ...
http://www.experts-exchange.com/Networking/Misc/Q_23203817.html
I want to upgrade the Flash card in a Cisco 2821 router from 64-256Megs
How do you get the current data from the original to the new one properly?
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23383199.html
Zones:
RoutersDate Answered: 05/22/2008 Grade: A Views: 0
Anyone have a sample router 2821 script and/or suggestions to help in this configuration so I don't start from scratch? We already have the hardware and I will be setting this up for the first tim...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21497402.html
Zones:
RoutersDate Answered: 07/28/2005 Grade: A Views: 8
I've never configured a dual port WIC card, and I can't figure out how to access the second port on a VWIC 2MFT-T1 controller card.
On the card the left port says: "CTRLR T1 1" and the right por...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21585181.html
Zones:
RoutersDate Answered: 11/07/2005 Grade: A Views: 4
Hi,
I have cisco 2821 configured with 2 serial interfaces, I have 2 T1 coming into this router bundled as 3 Mbps, one T1 goes into S0/0/0 the second goes into s0/1/0, The first interface is fin...
http://www.experts-exchange.com/Networking/Misc/Q_21929568.html
Hi,
Im having real problems with setting my new Network Module (NME-16ES-1G) After my router loads and boots successfully the EN (enabled light) is not lit on the card. I have read on Cisco docu...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21993091.html
Zones:
RoutersDate Answered: 09/29/2006 Grade: A Views: 18
Hi There,
is it possible to connect a VWIC-2MFT-G703 interface to another router with the same interface(Directly Connected)
and ping each other ?
Do i have to Use RJ48 ? or RJ45 will fit !
...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_22127226.html
Zones:
RoutersDate Answered: 01/31/2007 Grade: A Views: 11
