We've purchased a couple of HP Procurve 2848 gigabit switches to soup up our network. The existing infrastructure consists of Procurve 2650 and 2524 10/100 switches.
We've enabled spanning tree...
http://www.experts-exchange.com/Networking/Misc/Q_21592171.html
Zones:
Networking,
...Date Answered: 10/14/2005 Rating: 8.4 Views: 0
I really need an idiots guide on this one!
I've read through the documentation but I'm lost. It seems you can do it using the console cable or emulating a VT-100 console.
Thanks.
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23423955.html
We do have layer 3 switch (3com 4950) with a couple of VLANS with 2 more remote comp rooms connected via fiber cable to 4950 and few more local switches (mixed vendor, HP 2848, Dell 5324, and older...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_22854800.html
We are install two HP 2848 Layer 2/3 switches in out data center and adding three new VLANs, we currently do not have any VLANs. We have all the routing setup so we can ping from out lan to any of ...
http://www.experts-exchange.com/Networking/Network_Management/Network_Operations/Q_2303629...
We need to recover a password for our HP ProCurve J4904A - 2848 switch.
Could someone, please, send me step by step instructions to minimize possibility of an error and disconnecting our company...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23459966.html
I have 4 HP 2848s trunked into a CISCO 4510 using dual gig uplinks and FEC set on the HP side. We just got a new 2848 switch which has the most current firmware on it and they no longer support FE...
http://www.experts-exchange.com/Networking/Misc/Q_22029468.html
We have 2 HP ProCurve 2848 Switches that we are using to run a VLAN for our SAN. I have Certain ports on the 2 switches dedicated to the VLAN. We need to be able to route between VLAN 1 ( default )...
http://www.experts-exchange.com/Networking/Misc/Q_22628546.html
Looking for some help with 2 HP Procurve Swtiches (Model 2848) Switch 1 has 6 VLANS, and I need to extend those VLANs to a 2nd Switch, that has the same VLANS configured.
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23289720.html
Zones:
Routers,
N...Date Answered: 04/03/2008 Rating: 9.6 Views: 0
I have these 3 switches. I use a class C 192.168.10.0 subnet.
I ran out of available hosts (almost) I have two options.
supernet my existing subnet or route two subnets.
Im told routing is t...
http://www.experts-exchange.com/Networking/Network_Management/Network_Design_and_Methodolo...
Zones:
Net...Date Answered: 02/05/2009 Rating: 4.6 Views: 288
We currently have eight Procurve 2848 switches located in the same physical site/rack. Four of the switches are assigned IP addresses from a 10.10.20.x network and four switches are assigned IP add...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_22676753.html
