Enter Keywords:
1 - 10 of 27(0 seconds)
Sort By:
 
I have now got a config for my 2948G layer 3 switch, i cannot paste it into the unit because when i go into config terminal as advised, there is no command such as "show" . i can only see my sta...
Zones: RoutersDate Answered: 02/11/2005 Rating: 6.2 Views: 0
Hi all, i have just purchased a used 2948g layer 2 switch. Problem is that its config has not been removed and although the enable password is blank, it seems to have VLANS set up and it is not...
Zones: NetworkingDate Answered: 07/11/2005 Rating: 8.4 Views: 0
Hello guys! so here is the problem... i got from someone a cisco switch 2948G (surely a layer 2)... so I connected my pc to the console cable, access the console terminal... I tried to read some...
Zones: Networking, Netw...Date Answered: 11/18/2006 Rating: 9.4 Views: 4
Currently undergoing a network redesign I have to move one of our 2948G to another offce and configure it for VOiP Guessing I need VLAN and QoS set up but have no idea where to start novice ...
Zones: Switches / Hubs, VoIP, Network Design & Metho...Date Answered: 10/13/2008 Rating: 8.2 Views: 4
I am trying to reset a 2948g to factory defaults. Tried follow a method out of the online manual and it does not seem to work. One of the first steps was to issue a write erase command and this see...
Zones: Routers, N...Date Answered: 03/30/2009 Rating: 9.3 Views: 0
I want to set up a trunk connection between a 2900xl and a 2948G  ( **NOT** a 2948G-L3) a simple trunk connection for several different vlans not routing just switching thanks
Zones: Networking, Net...Date Answered: 08/25/2003 Rating: 7.0 Views: 0
Hi all, I am attempted to configure 2 VLANS on a Catalyst 2948 -LG Switch.  The end result would be 2 seperate networks that could exchange data back and forth. I would plug a hub into 1 port of...
Zones: Networking, ...Date Answered: 06/28/2004 Rating: 8.6 Views: 5
Hi, can anyone please send me a config file that i can past into the running config of my 2948 g L3. i JUST BOUGHT IT AND CANNOT GET IT TO WORK PROPERLY. it is not sending or recieving data through...
Zones: RoutersDate Answered: 01/27/2005 Rating: 8.8 Views: 0
Host computers have gigabit cards in them but they all connect at 100mbps for some reason...how can I check duplex settings on this switch, it appears to have no web interface.  Here's version info...
Zones: NetworkingDate Answered: 08/11/2005 Rating: 9.0 Views: 0
Hi guru's I have a cisco 2948 switch that has been tossed to us for our testing systems. I want to configure it as a basic switch for starters. Perhaps later implement VLANs and the like. Really ...
Zones: Networking, Netw...Date Answered: 09/02/2005 Rating: 9.4 Views: 73