Is there any configuration examples to show how to configure VLAN on Catalyst on 2950 and enable internal routing on Catalyst 3560 ?
Thanks
http://www.experts-exchange.com/Networking/Misc/Q_21858833.html
Hi,
I loaded a enterprise image "X" on the Switch, which is not working; fortunately I still have the orginal available in Flash, but I can't figure out how to set the boot back to the origiana...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21669075.html
Zones:
RoutersDate Answered: 12/21/2005 Rating: 8.4 Views: 100
Ok our network guy quit and being the Pix firewall expert i got stuck trying to configuring some new equipment for net week. Here is what i need to do but i don't know enough about Cisco Switch co...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21680279.html
Zones:
RoutersDate Answered: 01/27/2006 Rating: 8.6 Views: 0
Hey Guys,
anyone know of some good docs on intervlan routing on a catalyst 3560. I basically wanna know if I allow traffic from 1 vlan to another do I have to specify that same traffic from the...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21997042.html
Zones:
RoutersDate Answered: 09/25/2006 Rating: 9.4 Views: 0
Guys,
How can I reset enable password on cat 3560? I know the password just need to change it.
Thanks,
http://www.experts-exchange.com/Networking/Misc/Q_22100685.html
Zones:
NetworkingDate Answered: 01/25/2007 Rating: 7.2 Views: 0
Dear Experts
I have the following set up 2 Cisco 6513 Switches for full redundency,
Cisco 6513 Switches (2 for redundency (IOS Version 12.2(17d)SXB11) and they are connected to cisco 3550 S...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_22122183.html
Zones:
RoutersDate Answered: 01/16/2007 Rating: 8.4 Views: 35
I have two networks. seperated by a 100meg fiber direct link. (fiber has a ethernet converter at each end)
I have the link going in to two 3560 switches at each end. and I want to seperate them...
http://www.experts-exchange.com/Networking/Protocols/Q_22547622.html
There are several 2950 switches connected to a Core switch 3560. The problem is that when trying to telnet to any of the 2950 switches the telnet goes to the Core 3560 switch. If from the 3560 trie...
http://www.experts-exchange.com/Networking/Misc/Q_22903806.html
Zones:
Networking,
...Date Answered: 10/29/2007 Rating: 8.8 Views: 0
Hi experts! I have a cisco 3560 switch with a couple vlans..
I noticed that I can telnet to any of the vlan interfaces and it asks me for the password to log in. I would like to set up the switc...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23094419.html
i ahve a 3560 connecting to a 2811..the 2811 connects to a remote 2800 via
a t1..then the remote 2800 coonects to a 3560 via its ethernet port
i created vlan 21 on the local 3560 here for video...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23198785.html
