I am looking at implementing Cisco Call Manager Express for 32 users in our office. We are a single site office and I have heard so many differing opinions about what to do that I am hoping someone...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_22635476.html
Hi all; kind of new to the VoIP scene, so please bear with me.
I just purchased a Cisco 2851XM router and have successfully configured CME and about four 7970 phones to call each other internal...
http://www.experts-exchange.com/Networking/VoIP_Voice_over_IP/Q_22021604.html
Hello,
I'm not sure I entirely understand how BLF functions on the Cisco 7931G phones with Cisco CME.
We are a small business striving to give a human response to every call (we don't use any a...
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/IP_PBX/Q_236819...
Zones:
IP PBX,
VoIPDate Answered: 08/29/2008 Grade: A Views: 51
Is there a way to control the codec used per device/phone in CME?
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/VoIP/Q_23386172...
Hi,
I was wondering if it is possible to share the lines like a Key System on a Cisco 2811 when using a T1/E1 connection?
I have 20 7931G IP phones and I want to configure them so they each hav...
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/VoIP/Q_23549762...
Zones:
VoIPDate Answered: 09/08/2008 Grade: B Views: 4
We have a small office that utilizes Cisco CME in a Cisco 2821 ISR router. What I would like to do is set up the phones so that any calls that come in to our receptionist ring simultaneously on our...
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/IP_PBX/Q_233408...
I am very new to Cisco VoIP, so this is probably an easy question.
We have a Cisco 2801 ISR IOS 12.4(11)T running Call Manager Express and Unity Express w/ Cisco 7931 IP phones. For some reason...
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/VoIP/Q_23222940...
Zones:
VoIP,
RoutersDate Answered: 03/22/2008 Grade: A Views: 95
No caller id name displayed on outbound or inbound calls. Numbers show up. Telco says they are passing information. The connection is a t1/pri circuit.
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/VoIP/Q_23243106...
Zones:
VoIPDate Asked: 03/14/2008 Points: 500 Comments: 2
Hi,
I have a Cisco IP Phone that doesn't have a dialtone although the display at the panel looks normal. I can even forward it to a mobile.
I have done the following.
1. replace the phone itse...
http://www.experts-exchange.com/Networking/Network_Management/Q_23367604.html
Is there a way to remove DND from a phone in CME through either the command line (preferred) or the web interface? We have 134 sites that have CME and DND was included when the systems were origina...
http://www.experts-exchange.com/Networking/Telecommunications/IP_Telephony/Q_23476735.html
Zones:
IP TelephonyDate Answered: 06/11/2008 Grade: A Views: 38
