Is it possible to receive an alert (E-mail) when the port is disabled due to a port-security violation?
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23412957.html
I have a Cisco Catalyst 4510R (dual Sup V) on one end of a building and a pair of cascaded cat 3750G switches on the other. There are multiple connection points between the locations that I can us...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23418378.html
Hello again,
our catalyst doesnt have a management IP. I need to set one up so I can use snmp to get some stats.
whats the easiest way to do this. The switch cannot be reset or go down for ev...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_20752932.html
Hi,
we're a school with Cisco 2950 Catalyst switches around our campus. They connect to the core via fibre at 100 Mb/s - all into 3Com Superstack switches(?) There is presently no filtering or VL...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_21054743.html
Zones:
RoutersDate Answered: 07/13/2004 Grade: A Views: 0
This is my setup:
Comcast cable (with two dynamic IP addresses allocated to my modem)
Catalyst 2924
An assortment of boxes (including one wih two nics: i will refer to this a Linux-A)
Prior...
http://www.experts-exchange.com/Networking/Broadband/Q_21230496.html
Zones:
BroadbandDate Answered: 12/07/2004 Grade: B Views: 9
Dear Expert,
Currently have a few Cisco Catalyst Switches and of course ports are populated with various devices. Unfortunately, these switches are located remotely. Need to determine what dev...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_22420484.html
I am sending SNMP mac-address-notifications from a Cisco Catalyst 3750 Switch. Using Kiwi Syslog I am able to receive the traps and can see the information regarding the MAC-Address when it is plug...
http://www.experts-exchange.com/Networking/Network_Management/Network_Operations/Q_2281349...
I have a Cisco 3750G setup as a core, root switch. Two Cisco 2950's connect to this switch and both links are set to trunk, passing native vlan 1 and vlan 27. One of the switches will only pass v...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23179891.html
I am trying to setup a alert system that would allow for me to recieve snmp and syslog messages to my SolarWinds server. Currently I have all snmp traps setup on my switches. But, what do the follo...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23257153.html
Hi
I connect the switch from the console port to the com port on my pc. start hyperterminal, set the rate to 9600 baud, turn on the switch and holding the mode button until it stops blinking. Then...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23317082.html
