hello i we have a cisco 1841 with with HWIC-4ESW .
i would like to set up a vlan5 (192.168.200.0) i would like traffic on this vlan to be able to reach our existing network of 10.17.18.0 and vi...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23466158.html
Zones:
Routers,
N...Date Answered: 06/09/2008 Rating: 6.7 Views: 165
Had a miserable time in the data centre tonight ....
I have two routers, each with an HWIC-4ESW card ... I want to connect fast ethernet 0/0/0 on 1st router to fastethernet 0/0/0 on the second rou...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_24350479.html
I have a Cisco 1841 with a 4 port FastEthernet switch HWIC and a 802.11 b/g HWIC. Internet service is comming from FastEthernet0/0. Currently I have FastEthernet0/1 connected to an external switch ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23014653.html
Zones:
RoutersDate Answered: 07/08/2008 Rating: 7.0 Views: 4
We have three 1841 ISR routers and want to use them in a three-point MPLS.
Do we need to use an FE port on each router (FE0/0) for the MPLS or can we use a port off of an HWIC-4ESW (FE0/1/1) ins...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_24008443.html
Zones:
RoutersDate Answered: 12/30/2008 Rating: 5.4 Views: 0
Hi All,
I'm trying to configure vlans in Cisco 3825 using HWIC-4ESW module. The router shows the module is installed properly and I configured the VLAN too. but the line protocol of the FE and V...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_24294772.html
Zones:
Routers,
...Date Answered: 04/09/2009 Rating: 8.7 Views: 123
hello i we have a cisco 1841 with with HWIC-4ESW .
i have set up a vlan5 (192.168.200.1) i would like traffic on this vlan to be able to reach our existing network of 10.17.18.0 and vice versa....
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23469320.html
Zones:
Routers,
...Date Answered: 08/29/2008 Rating: 2.6 Views: 86
Hello All,
We have a Cisco 1841 with a HWIC-4ES4 with a simple config and need to do a NAT between 2 vlans.
We need that all traffic from 192.168.16.0/24 with destination for 10.1.0.0/16 and ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_24415109.html
Zones:
RoutersDate Asked: 05/16/2009 Points: 500 Comments: 9
