I am having trouble accessing the internet through this router. It is plugged into a iDiredt 3100 Series Sat Modem. Can ping the modem, but not the DNS servers or and other outside IP. I think I...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23085084.html
Zones:
RoutersDate Answered: 01/21/2008 Grade: A Views: 0
We have a router that has been replaced but the former IT person didn't leave the password for it. We have tried everything and can not figure it out. Since it is out of production we can deal wi...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23114092.html
I am in the process of getting Qwest Integrated Access service installed. It is basically a T1 that they split between voice and internet. The device that they use to split it is a Cisco 2811 route...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23121901.html
I've been using this Cisco 877 router at a small office for about 9 months without any problems. Last Friday there were employees working at the office and one remote user connected through the ci...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23233599.html
Zones:
RoutersDate Answered: 04/14/2008 Grade: A Views: 34
If you have an ISR 2821 at your main site and three ISR 1841's at three seperate remote sites and are using EIGRP for routing, does one need to use seperate subnets for each circuit, say:
Main ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23239914.html
Zones:
RoutersDate Answered: 03/14/2008 Grade: B Views: 4
Hi,
I am in the process of configuring a DMVPN between 3 x Cisco 1841's. I have never previously done this so I am not 100% that what I have configured will work. My config's are below. My ma...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23411055.html
What I am trying to do is connect a cisco 871w to our current network and have 2 SSIDs on it. One for guest access and one that is connected to our current network. Right now I have 2 VLANs one on ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23449725.html
Hello all,
We have a Cisco ISR 2811 router that we are currently using for testing (i.e. if we lose the config, no big deal). We are currently getting ready to test out our IPv6 backbone - in o...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23453941.html
I have new 861W router and cannot get it configured. I have loaded CP Express on it, but it doesn't seem to hold config. CLI works but I still can't get the WLAN to turn on a broadcast and I cannot...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23651803.html
How to setup a VPN tunnel from one cisco router to another cisco router?
I have a situation where I need to establish a VPN tunnel between two cisco routers. I have been given the IKE (Phase 1)...
http://www.experts-exchange.com/Security/Software_Firewalls/Enterprise_Firewalls/Cisco_PIX...
