Advertisement

1 - 10 of 44 containing alltags:("Switch and Router") (0.001 seconds)
Can someone explain in details the differences between Hubs, Switches and Routers ? Also, what topology does Routers use and what are their Standard Compliance and maximum transmission rate ?
Zones: Networking, Switches / Hubs, FTPDate Answered: 02/26/2005 Grade: A Views: 83
This is a small network, with only about 6 workstations that share printers, a single network (Shared) drive and require internet (DSL) access. There is no locally hosted email server. I'm basic...
Zones: Networking Hardware, Routers, Switch...Date Answered: 06/17/2008 Grade: B Views: 0
To the experts outhere, I am planning on designing a network from the ground up for my brothers electronic supply chain, would I be better off setting it up with Lan switches alone or also with rou...
Zones: Networking, Switches / Hubs, FTPDate Answered: 06/29/2004 Grade: B Views: 0
ok here's the scenario. our office is scattered into three different floors in a building. one on 8th, 12th, and 23rd. we are in the process of centralizing the network making each department use a...
Zones: Networking, Switches / Hubs, FTPDate Answered: 07/20/2004 Grade: A Views: 0
I asked a question yesterday about hooking up a router or hub or switch in the front office so i didnt have to run some more cable from the server room and everybody told me to go with the switch. ...
Zones: Windows 2000Date Answered: 02/02/2005 Grade: B Views: 0
Hello, Not sure if this question belongs here or in hardware.  I have a 8-port router in which 7 of the ports are being used, 2 network printers and 5 computers.  I want to add more computers, s...
Zones: Networking, Switches / Hubs, FTPDate Answered: 01/20/2006 Grade: A Views: 43
I have read that a layer2 switch may not have an IP address.  If this is the case, how does a router (layer 3) know how to send a packet to a pc connected to a switch?  The router sends packets bas...
Zones: Networking, Switches / Hubs, FTPDate Answered: 03/01/2006 Grade: A Views: 0
I want to setup a switch in my attic where currently it is 115 degrees F and approx 35% humidity. The specs for the linksys router I am looking at state the follwoing: Operating temp: 32F to 122...
Zones: Networking, Networking HardwareDate Answered: 07/09/2006 Grade: A Views: 9
Hi experts, Did you have any idea to solve the virus problem remotely. assuming i on outside. we have equipment cisco router 2600s (connect to ISP) and every floor switch using 3com. firewall ju...
Zones: Cisco PIX FirewallDate Answered: 07/05/2008 Grade: A Views: 0
Dear Users, I have been advised to disable rlogin service on the Routers and Switches. Could anyone tell me how can I do it? Thanks
Zones: Routers, Switches / HubsDate Answered: 10/29/2008 Grade: A Views: 4