I wanted to get a few opinions on the way our network is setup.
We have 2 locations in different states: Corp Office, Call Center
They are connected Via 3M (2 x T1) MPLS Circuit
The call cente...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Q_23092720.html
I have a small network set up with a server that acts as DHCP. The router mentioned is connected to a regular broadband service. There are a couple of portables connected via wireless to the router...
http://www.experts-exchange.com/Networking/Broadband/Q_23317963.html
I have a few different IOS-software loads (c2800nm-xxx-124-8, c2800nm-xxx-124-11, c2800nm-xxx-124-15)
I was told that if I change the order of the files on flash, then when I restart the IOS it...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Q_23386115.html
Here is the output of the errors I am getting. This is the same call made twice with different switch errors. I know what the error codes mean, just not sure why I am getting them or how to resol...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23039343.html
Zones:
Routers,
VoIPDate Asked: 12/21/2007 Points: 250 Comments: 3
I am hiring an ISDN analyser which I am assured "does L1". This I agree would be necessary to independently verify the clocking setup of an E1 trunk between a Cisco IOS voice gateway (AS5350) and a...
http://www.experts-exchange.com/Networking/Telecommunications/Legacy_PBX/Q_23226963.html
Dear All
We have a CISCO 2801 router(VG). This VG is connected with an E1 DID line that contains 100 extentions (from 7600 to 7699).We want to configure the VG so that any call comes to a speci...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23274571.html
