Hello all - does any one know if the 2960 series supports basic routing - i.e. static routes?
Also, do they support HSRP? I would like to use a pair of 2960s and have a VLAN exist on both, but ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23076338.html
Hi, I have the following required from our phone vendor..
*****
Vlan2 will be created on our router to support the data network. This will be the logical connection between the router and the fi...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23522078.html
Im trying to setup VTP trunking on s cisco 2960 which has 24 fastethernet ports and 2 gig ports. If i set one of the fastethernet ports to trunk mode it works fine but not on the gig ports.
Cou...
http://www.experts-exchange.com/Networking/Network_Management/Network_Analysis/Q_23533036....
I'm completely new to VLANs, but what I've read about them is very interesting, and will potentially be a significant increase in our security. Unfortunately, I'm pretty sure I'm only getting abou...
http://www.experts-exchange.com/Networking/Network_Management/Network_Design_and_Methodolo...
Hello,
I have a requirement to limit the amount of bandwidth used by certain hosts to communicate to the Internet (but not internally from one host to another within the switches). My network i...
http://www.experts-exchange.com/Networking/Network_Management/Network_Design_and_Methodolo...
Hi there......
I have an existing Cisco 3750 infrastructure and I wish to add a new Cisco 2960 to it. The Core 3750 switch is configured with VLAN100 to act as a new data VLAN with a 10.244.19.2...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23061903.html
I have two questions:
1: Why will my Cisco 2960 switch not accept the "ip route" command?
2: How do I export the config of the 2960 switch so I can view the format in notepad?
Please see the...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23070768.html
I have a strange IP with this message from my PIX: Error --- %PIX-3-305005: No translation group found for udp src inside:169.254.18.19/138dst outside:169.254.255.255/138.
I want to find the IP ...
http://www.experts-exchange.com/Networking/Security/Q_23152675.html
We use Ghost but only in an isolated lab environment to prevent tearing down our network during sessions. I would like to run over the LAN and possibly the WAN one day...question below:
How woul...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23369180.html
Hello Guys,
I have a Cisco Catalyst 2960 Switch (WS-C2960-48TT-L).
On what I have seen on the internet, it can perform multi-layer switching especially Layer 3.
So I made 2 vlans for testing. ...
http://www.experts-exchange.com/Hardware/Networking_Hardware/Switches/Q_23344553.html
