Browse All Articles
> How To Set Up Wake on LAN to Turn Your Computer On Over The Internet
I was recently sitting at a desk at work with one of my colleagues and needed some information on my home computer. He watched as I turned on my home computer, established a remote session into it, got the information I needed and then shut it down again (I don't believe in leaving the computer turned on and wasting power).
"So that was interesting," said my colleague. "How did you set that up?"
The first thing to know about waking up your computer over the Internet is that not all home firewall/routers are going to be able to do it. Check the specs of your device. Along with the usual things like port forwarding, it needs to support static ARP entries. If it can, it's relatively straightforward.
First of all, set a static IP address on your target machine. Then go into the properties of the network card and enable Wake on LAN if it is not already enabled (It's usually enabled by default). You may have to enable Wake on LAN in the BIOS as well. Record the MAC address of your machine as you will need this to wake it (you can get this at the command prompt with an ipconfig /all ).
Next, you need to register the static IP address of your machine in the ARP table of your router. This is the part that some firewall/router devices targeting the home market are not going to be able to do. You will need to refer to your devices manual or support site to determine how to do this. You may not be able to do this while the network interface you are registering is connected to the network, so you may require another network interface or a second computer.
Finally, you need to set up a virtual server on your firewall with the following parameters:
Use the UDP protocol.
Use 9 for the internal port.
Use your static IP address of the target computer for the internal address.
Use any common port for the external port, but choose one not already in use. If you don't have a POP3 Mail server for instance, you could use 110.
I would also advise that you set up a Dynamic DNS. Many home firewall/router devices will be able to register their address automatically with one of these sites (for example: http://www.dyndns.com
.) This enables you to just remember a FQDN entry instead of an IP address and will also update if your public IP address changes.
Now you should be able to turn off your computer and use another computer, or even a smart phone to send a magic packet to wake up the computer. I use http://www.depicus.com/wake-on-lan/woli.aspx
Just enter the MAC address of the computer, the IP address or FQDN, 255.255.255.255 as the subnet mask (as you are targeting a single host) and the port number you registered as the external port for your virtual server. Click the WAKE ON LAN button and your computer should turn itself on moments later!
If you have another virtual server set up to relay VNC or RDP to your machine, you can then control the machine remotely.