Solved

Agetty

Posted on 1997-01-21
1
212 Views
Last Modified: 2010-04-20
How do I get agetty to work. I would be using cua1 or ttyS1. How do I configure it so that it works???
0
Comment
Question by:maxell
1 Comment
 
LVL 1

Accepted Solution

by:
mstonge earned 100 total points
ID: 1584099
Edit your etc/inittab and place the following:

d0:3:respawn:/sbin/agetty -h -t60 38400 ttyS1

I assume that you run linux in level 3 but you may use a different run level.


Marc    
0

Featured Post

Microsoft Certification Exam 74-409

Veeam® is happy to provide the Microsoft community with a study guide prepared by MVP and MCT, Orin Thomas. This guide will take you through each of the exam objectives, helping you to prepare for and pass the examination.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
Although Jacob Bernoulli (1654-1705) has been credited as the creator of "Binomial Distribution Table", Gottfried Leibniz (1646-1716) did his dissertation on the subject in 1666; Leibniz you may recall is the co-inventor of "Calculus" and beat Isaac…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question