• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 206
  • Last Modified:

Linux Setup

I am setting up Linux on a Micron Millennia Transport Laptop. P133/32/1.3 12.1AM Once I get into LILO my display goes out and I cannot see anything. I think that I need some overrides for this, but I do not know what they are. Help!
0
michaeldaviso
Asked:
michaeldaviso
1 Solution
 
ylaiCommented:
The method to remove LILO is,
1.  Reboot your machine with some sort of boot up disk, like DOS start up disk.
2.  type fdisk /mbr and it will remove LILO from the boot sector.
3.  Next time you boot your machine, it will go to the previous OS.

Good luck!!!
0
 
michaeldavisoAuthor Commented:
I am trying to set up Linux not remove it!!
0
 
ed1Commented:
The procedures described by ylai were not to 'remove' Linux, only to remove LILO from the boot sector of your hard drive. I would recommend doing exactly what ylai says, then, booting from your boot disk, re-install LILO.
0
 
borisrCommented:

  Did you try to Configure LILO. It is a pretty easy procedure when you are installing linux setup asks you to Configure LILO. I am saying it because when I first installed linux I didn't do it.
In setup you have to inform LILO what partition do is your linux at and only then proceed to install LILO. If you didn't do it you have to run linux's setup by booting linux with the boot and root
flopies. Run setup, go to configure linux, and then read carefully the instructions that are given by setup program to you and follow them, especially when you will be configureing LILO. Then try to reboot your computer.
0

Featured Post

Get your Conversational Ransomware Defense e‑book

This e-book gives you an insight into the ransomware threat and reviews the fundamentals of top-notch ransomware preparedness and recovery. To help you protect yourself and your organization. The initial infection may be inevitable, so the best protection is to be fully prepared.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now