3c509, Digi Xem & Buslogic

I just installed the latest Redhat from ftp.digital.com
on an IDE drive, and I am having a hell of a time configuring it to recognize the following hardware:

BusLogic 9466 PCI SCSI Card  - i/o 0x330
2 Digiboards Xem's -
1 at - 0x104 and irq 15
1 at - 0x204 and irq 3 (com2 is already disabled)
2 3COM 3c509 adapters
1 at - 0x250 - irq 10
1 at - 0x300 - irq 9

I worked 37 hours this past weekend, read the Serial-HOWTOS, Ethernet* HOWTOS, installed the
Digiboard patch from ftp.dgii.com, ran digiconfig,
rebuilt the kernal about 40 times, would have drank
about 100 cups of coffee (but I dont drink coffee) -
you get the idea -

Also - since I have 2 network cards, I will be setting
up dial-up PPP to use dynamic ips from each of these
networks - is this possible?  Is there any change
in the ppp/options, or options.cudXX files, or
can I just put    cards ips:port assigned ip
in these options.cudXX files???

Also - how do I configure slip for the same type
of setup.  i.e. at the prompt, the user types slip,
and gets a dynamic ip - I couldn't find this anywhere
in the HOWTO's.


Thank you ever so much.

I will much happier when this is all over!  Im tired! :(


Jordan