mikemartin
asked on
BSR-DAK Mouse driver
I need a 3 button mouse driver for a BSR-DAK wireles 3 button mouse, it works in 2 button mode with the Logitech 7.0 driver but thr middle button is not recognized.
Mikemartin@earthlink.net
Mikemartin@earthlink.net
Go to Start/settings/control panel/mouse/devices/add device. After you add the device, got to the button assignment tab.
This should work. If it doesn't, go to controll panel, then add new hardware. THen run the mouse configuration. If it STILL doesn't work, try looking on the internet for some mouse drivers, THEN try the procedures above. Good Luck!
-Dev
This should work. If it doesn't, go to controll panel, then add new hardware. THen run the mouse configuration. If it STILL doesn't work, try looking on the internet for some mouse drivers, THEN try the procedures above. Good Luck!
-Dev
ASKER
Already done that, what i realy need is what mouse the BSR-DAK mouse was compatiible with
Mike
Mike
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Mike